93XX46X/56X/66X/76X/86X
The DO pin indicates the Ready/Busy status of the
device if CS is brought high after a minimum of 250 ns
low (TCSL). DO at logical ‘0’ indicates that programming
is still in progress. DO at logical ‘1’ indicates that the
register at the specified address has been erased and
the device is ready for another instruction.
3.4
ERASE
The ERASE instruction forces all data bits of the
specified address to the logical ‘1’ state. CS is brought
low following the loading of the last address bit. This
falling edge of the CS pin initiates the self-timed
programming cycle, except on ‘93CXX’ devices where
the rising edge of CLK before the last address bit
initiates the write cycle.
Note:
After the Erase cycle is complete, issuing
a Start bit and then taking CS low will clear
the Ready/Busy status from DO.
FIGURE 3-1:
ERASE TIMING FOR 93AAXX AND 93LCXX DEVICES
TCSL
Check Status
CS
CLK
DI
1
1
1
AN
AN-1 AN-2
A0
•••
TSV
BUSY
TCZ
High-Z
DO
Ready
High-Z
TWC
FIGURE 3-2:
ERASE TIMING FOR 93CXX DEVICES
TCSL
Check Status
CS
CLK
1
1
1
AN
AN-1 AN-2
A0
•••
DI
TSV
TCZ
High-Z
DO
Busy
Ready
High-Z
TWC
© 2007 Microchip Technology Inc.
DS21929D-page 11
MICROCHIP [ MICROCHIP ]
