MIC39100/39101/39102
Micrel
Quick Method
∆T = T
– T
A(max)
J(max)
Determine the power dissipation requirements for the design
along with the maximum ambient temperature at which the
device will be operated. Refer to Figure 5, which shows safe
operating curves for three different ambient temperatures:
25°C, 50°C and 85°C. From these curves, the minimum
amount of copper can be determined by knowing the maxi-
mum power dissipation required. If the maximum ambient
temperature is 50°C and the power dissipation is as above,
836mW, the curve in Figure 5 shows that the required area of
T
= 125°C
J(max)
T
= maximum ambient operating temperature
A(max)
Forexample, themaximumambienttemperatureis50°C, the
∆T is determined as follows:
∆T = 125°C – 50°C
∆T = 75°C
Using Figure 4, the minimum amount of required copper can
be determined based on the required power dissipation.
Power dissipation in a linear regulator is calculated as fol-
lows:
2
copper is 160mm .
The θ of this package is ideally 63°C/W, but it will vary
JA
depending upon the availability of copper ground plane to
which it is attached.
P = (V – V
) I
+ V · I
D
IN
OUT OUT IN GND
If we use a 2.5V output device and a 3.3V input at an output
current of 1A, then our power dissipation is as follows:
P = (3.3V – 2.5V) × 1A + 3.3V × 11mA
D
P = 800mW + 36mW
D
P = 836mW
D
From Figure 4, the minimum amount of copper required to
2
operate this application at a ∆T of 75°C is 160mm .
June 2000
11
MIC39100/39101/39102
MICREL [ MICREL SEMICONDUCTOR ]
