MLX90316
Evaluation Board
Demonstration Board
Related Products
MLX90316 Tria9isTM Rotary Position Sensor
Related Documents
Datasheet MLX90316
Applications Note Back-End Calibration
Applications Note Magnets for MLX90316 Rotary Position Sensor
Applications Note Hall Applications Guide
Related Tools
PTC04 Programmer for Melexis PTC devices
Ordering Information
Part No.
Description
EVB_MLX90316DC
EVB_MLX90316GO
DMB_MLX90316
Evaluation Board MLX90316xDC – SOIC-8 Package
Evaluation Board MLX90316xGO – TSSOP-16 Package
Demonstration Board MLX90316
1. Evaluation Board (EVB_MLX90316DC)
1.1. Description
The EVB_MLX90316DC consists into a Printed Circuit Board (PCB) and Magnetic Knob.
•
The PCB implements the recommended application diagram from the MLX90316 datasheet. The
MLX90316DC (SOIC-8) is mounted on the board. It also includes an aluminum ring in order to center
the magnetic knob (see below) above the sensitive area of MLX90316. By default, the output transfer
characteristic is programmed to get a 10%Vdd ... 90%Vdd analog output swing for 0 … 360 Degrees
travel (complete revolution).
•
The magnetic knob features a small SmCo magnet diametrally magnetized D6H2.5 (Diameter = 6 mm
and Height = 2.5 mm).
1.2. Application Diagram
The Pin SCLK and /SS are left floating in order to enable the use of the EVB in Serial Protocol mode. If
this mode is not activated, we recommend shorting those pins to GND through 0 Ohm resistor. It is
mandatory to run EMI test.
If the Serial Protocol mode is activated, the PCB allows the introduction of decoupling capacitor.
39xx9031601
Rev 001
Page 1 of 6
Apr. 06
MELEXIS [ Melexis Microelectronic Systems ]
