-
ECOM1
CAPP1
CAPN1
MAT1
TOG1
PWM1
ECCF1
SFR: CCAPM2 (PCA Module-2 Mode Register)
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
-
ECOM2
CAPP2
CAPN2
MAT2
TOG2
PWM2
ECCF2
SFR: CCAPM3 (PCA Module-3 Mode Register)
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
-
ECOM3
CAPP3
CAPN3
MAT3
TOG3
PWM3
ECCF3
ECOMn := used to determine if Enable Comparator
0:= (default)
Disable the comparator function
1:=
Enable the comparator function
CAPPn := configure the module-n’s register to latch the PCA counter on Positive edge of EXIn
or not
0:= (default)
configure the module-n’s register not to latch the PCA counter on CEXn posedge.
1:=
configure the module-n’s register to latch the PCA counter on CEXn posedge.
CAPNn := configure the module-n’s register to latch the PCA counter on Negative edge of
EXIn or not
0:= (default)
configure the module-n’s register not to latch the PCA counter on pin CEXn negedge.
1:=
configure the module-n’s register to latch the PCA counter on pin CEXn negedge.
MATn := used to determine if set the bit CCFn in SFR CCON while a match from module-n
occurs..
0:= (default)
Don’t set the bit CCFn while a match occurs between the PCA counter and module-n’s
register.
1:=
Set the bit CCFn while a match occurs between the PCA counter and module-n’s
register.
TOGn := Toggle the output pin
0:= (default)
Don’t toggle the pin CEXn while a match occurs between the PCA counter and
module-n’s register.
1:=
Toggle the pin CEXn while a match occurs between the PCA counter and
module-n’s register.
PWMn := Enable plus width modulation mode n .
0:= (default)
Inhibit the PWM functionality from module-n output to pin CEXn
1:=
Enable the pin CEXn as the output of the PWM functionality from module-n
ECCFn := Enable the CCFn flag in the CCON SFR to generate an interrupt.
0:= (default)
Inhibit the interrupt (CCFn) from module-n to the MCU
1:=
Permit the interrupt (CCFn) from module-n to the MCU
42
MPC82x54A Data Sheet
MEGAWIN
MEGAWIN [ MEGAWIN TECHNOLOGY CO., LTD ]
