(Continued)
Symbol Parameter
Test Conditions
Min Typ*1 Max Unit
Fosc=6MHz,
Tamb= -40℃
2.4
T
T
amb= +25℃
amb= +85℃
2.1
1.8
-
-
-
5.5
5.5
Fosc=12MHz,
Tamb= -40℃
T
T
*5, *8
2.4
2.2
1.9
VDD
Power supply voltage
V
amb= +25℃
amb= +85℃
Fosc=24MHz,
Tamb= -40℃
T
T
2.4
2.4
2.4
amb= +25℃
amb= +85℃
5.5
-
Tamb= -40℃
T
T
2.4
2.1
1.8
amb= +25℃
amb= +85℃
VPOR
Power-on reset threshold voltage
Power supply current, operating*7
-
V
VDD=2.7V
Fosc=6MHz
Fosc=12MHz
Fosc=24MHz
VDD=5.5V
4.7
6.9
11.0
6.0
8.5
13.5
-
-
-
mA
Fosc=6MHz
Fosc=12MHz
Fosc=24MHz
8.9
11.6
18.1
11.0
14.0
22.0
VDD=2.7V
*6
IDD
Fosc=6MHz
Fosc=12MHz
Fosc=24MHz
1.9
2.9
5.0
2.5
3.5
6.0
Power supply current, idle
mA
VDD=5.5V
Fosc=6MHz
Fosc=12MHz
Fosc=24MHz
4.1
5.1
8.1
5.0
6.5
10.0
-
-
F
osc=24MHz,
VDD=2.7V~5.5V
Power supply current, power-down
1
10
μA
Note:
*1: Typical values are based on a limited number of samples and are not guaranteed. The values listed are at
room temperature unless otherwise specified.
*2: Port pins source a transition current when used in quasi-bidirectional mode and externally driven from logic 1
to logic 0. This current is highest when VIN is approximately 2.0V.
*3: See Section 29: Absolute Maximum Ratings for steady state (non-transient) limits on IOH and IOL.
If IOH exceeds the test condition, VOH will be lower than the listed specification.
If IOL exceeds the test condition, VOL will be higher than the listed specification.
*4: Supply voltage for RAM data retention.
*5: With the Hardware Option ENLVRO & ENLVRC disabled.
*6: With the Hardware Option OSCDN enabled.
*7: Tested while CPU running in a NOP loop, as shown below.
Loop:
NOP
JMP Loop
*8: The listed minimum supply voltage is obtained under normal work of logic function, excluding Flash erase and
write. The range 2.7V~5.5 is the supply voltage for normal work of whole chip function.
MEGAWIN
MPC82G516A Data Sheet
136
MEGAWIN [ MEGAWIN TECHNOLOGY CO., LTD ]
