MX23J25640
Sequential Read
In read modes (1), (2), and (3), when a command (00H, 01H, 50H) is input and an address specified, if it is in the
block that includes the address that was specified first, the address is automatically incremented and the read
operation is continuously performed until the last address in the same block, by inputting the RE# clock. At this time,
a Busy period (tR) occurs after the last address is accessed in a page.
Note
Command
input
Command
input
Address
input
Page M
data output
Page M+1
data output
Output of in last page
in block
Address
input
Data output
00H
01H
50H
00H
01H
50H
Note
tR
tR
tR
tR
tCRY
tR
RB
Busy
Busy
Busy
Busy
Busy
Busy
In same block
(Maximum of 32 pages)
Note :To perform read again after reading the 527th byte of data of the last page of block, stop the read operation once, and
then restart the read operation by inputting again the read command and an address.
Relationship Between Command and Start Address (SA) during Sequential Read
(A)
(B)
(C)
(A)
(B)
(C)
(A)
(B)
(C)
0
256
512 527
256
512 527
256
512 527
SA
SA
SA
1block
=32 pages
Note
Sequential read mode (1)
(When "00H" command is input)
Sequential read mode (2)
(When "01H" command is input)
Sequential read mode (3)
(When "50H" command is input)
Note : When the "50H" command is set, only the (C) area (redundancy data part) is continuously read.
• When the "00H" command is set, the start address (SA) is set to area (A).
• When the "01H" command is set, the start address (SA) is set to area (B).
• When the "50H" command is set, the start address (SA) is set to area (C).
P/N:PM1137
REV. 1.2, OCT. 28, 2005
12