±15kV ESD-Protected, +5V RS-232 Transceivers
MAX202E–MAX213E, MAX232E/MAX241E
__________Applications Information
Capacitor Selection
The capacitor type used for C1–C4 is not critical for
proper operation. The MAX202E, MAX206–MAX208E,
MAX211E, and MAX213E require 0.1µF capacitors,
and the MAX232E and MAX241E require 1µF
capacitors, although in all cases capacitors up to 10µF
can be used without harm. Ceramic, aluminum-
electrolytic, or tantalum capacitors are suggested for
the 1µF capacitors, and ceramic dielectrics are
suggested for the 0.1µF capacitors. When using the
minimum recommended capacitor values, make sure
the capacitance value does not degrade excessively
as the operating temperature varies. If in doubt, use
capacitors with a larger (e.g., 2x) nominal value. The
capacitors’ effective series resistance (ESR), which
usually rises at low temperatures, influences the
amount of ripple on V+ and V-.
Use larger capacitors (up to 10µF) to reduce the output
impedance at V+ and V-. This can be useful when
“stealing” power from V+ or from V-. The MAX203E and
MAX205E have internal charge-pump capacitors.
Bypass V
CC
to ground with at least 0.1µF. In
applications sensitive to power-supply noise generated
by the charge pumps, decouple V
CC
to ground with a
capacitor the same size as (or larger than) the charge-
pump capacitors (C1–C4).
V+ and V- as Power Supplies
A small amount of power can be drawn from V+ and V-,
although this will reduce both driver output swing and
noise margins. Increasing the value of the charge-pump
capacitors (up to 10µF) helps maintain performance
when power is drawn from V+ or V-.
Driving Multiple Receivers
Each transmitter is designed to drive a single receiver.
Transmitters can be paralleled to drive multiple
receivers.
Driver Outputs when Exiting Shutdown
The driver outputs display no ringing or undesirable
transients as they come out of shutdown.
High Data Rates
These transceivers maintain the RS-232 ±5.0V
minimum driver output voltages at data rates of over
120kbps. For data rates above 120kbps, refer to the
Transmitter Output Voltage vs. Load Capacitance
graphs in the
Typical Operating Characteristics.
Communication at these high rates is easier if the
capacitive loads on the transmitters are small; i.e.,
short cables are best.
Table 2. Summary of EIA/TIA-232E, V.28 Specifications
PARAMETER
0 Level
Driver Output Voltage
1 Level
Driver Output Level, Max
Data Rate
0 Level
Receiver Input Voltage
1 Level
Receiver Input Level
Instantaneous Slew Rate, Max
Driver Output Short-Circuit Current, Max
V.28
Transition Rate on Driver Output
EIA/TIA-232E
Driver Output Resistance
-2V < V
OUT
< +2V
4% of the period
300Ω
13
3kΩ
≤
R
L
≤
7kΩ, C
L
≤
2500pF
-3V to -15V
±25V
30V/µs
100mA
1ms or 3% of the period
3kΩ to 7kΩ load
No load
3kΩ
≤
R
L
≤
7kΩ, C
L
≤
2500pF
-5V to -15V
±25V
Up to 20kbps
+3V to +15V
CONDITIONS
3kΩ to 7kΩ load
EIA/TIA-232E, V.28
SPECIFICATIONS
+5V to +15V
______________________________________________________________________________________
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
