DS1305
PIN DESCRIPTION
PIN
DIP
TSSOP
1
1
NAME
V
CC2
FUNCTION
2
2
V
BAT
3
3
X1
4
5
5
4, 6, 8,
13, 19
X2
N.C.
Backup Power Supply. This is the secondary power supply pin. In systems
using the trickle charger, the rechargeable energy source is connected to this
pin.
Battery Input for Standard +3V Lithium Cell or Other Energy Source. If not
used, V
BAT
must be connect to ground. Diodes must not be placed in series
between V
BAT
and the battery, or improper operation will result. UL
recognized to ensure against reverse charging current when used in
conjunction with a lithium battery. See “Conditions of Acceptability” at
www.maxim-ic.com/TechSupport/QA/ntrl.htm.
Connections for Standard 32.768kHz Quartz Crystal. The internal oscillator is
designed for operation with a crystal having a specified load capacitance of
6pF. For more information on crystal selection and crystal layout
considerations, refer to
Application Note 58: Crystal Considerations with
Dallas Real-Time Clocks.
The DS1305 can also be driven by an external
32.768kHz oscillator. In this configuration, the X1 pin is connected to the
external oscillator signal and the X2 pin is floated.
No Connection
Active-Low Interrupt 0 Output. The
INT0
pin is an active-low output of the
DS1305 that can be used as an interrupt input to a processor. The
INT0
pin
can be programmed to be asserted by only Alarm 0 or can be programmed to
be asserted by either Alarm 0 or Alarm 1. The
INT0
pin remains low as long
as the status bit causing the interrupt is present and the corresponding interrupt
enable bit is set. The
INT0
pin operates when the DS1305 is powered by V
CC1
,
V
CC2
, or V
BAT
. The
INT0
pin is an open-drain output and requires an external
pullup resistor.
Active-Low Interrupt 1 Output. The
INT1
pin is an active-low output of the
DS1305 that can be used as an interrupt input to a processor. The
INT1
pin
can be programmed to be asserted by Alarm 1 only. The
INT1
pin remains
low as long as the status bit causing the interrupt is present and the
corresponding interrupt enable bit is set. The
INT1
pin operates when the
DS1305 is powered by V
CC1
, V
CC2
, or V
BAT
. The
INT1
pin is an open-drain
output and requires an external pullup resistor. Both
INT0
and
INT1
are open-
drain outputs. The two interrupts and the internal clock continue to run
regardless of the level of V
CC
(as long as a power source is present).
Ground
Serial Interface Mode. The SERMODE pin offers the flexibility to choose
between two serial interface modes. When connected to GND, standard 3-wire
communication is selected. When connected to V
CC
, SPI communication is
selected.
Chip Enable. The chip-enable signal must be asserted high during a read or a
write for both 3-wire and SPI communication. This pin has an internal 55k
pulldown resistor (typical).
Serial Clock Input. SCLK is used to synchronize data movement on the serial
interface for either the SPI or 3-wire interface.
6
7
INT0
7
9
INT1
8
9
10
11
GND
SERMODE
10
11
12
14
CE
SCLK
3 of 22
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
