RAYCHEM Tubing Products
Model 19
Belt Heater for Heat-
Shrinkable Tubing Products
Product Facts
I Closed-loop speed and
temperature control
I Continuous controlled
process
2
I Adaptable for different
applications
I CE approved for worldwide use
I Self-diagnostic circuitry
I Parts counter and hour meter
tubing. Temperature and
speed can be controlled
to accommodate a wide
variety of products and
substrates.
Applications
Control Heating Zone
Minimal Skill Requirements
The Model 19 conveyor
type processor is a reliable
and versatile process
heater which provides a
controlled process for a
wide variety of heat-shrink-
able products.
The Model 19 processor
has two stamped foil heating guides for aligning the
elements that are manufac-
tured to a strict wattage
specification.
There are clearly marked
assemblies as well as the
tubing or device being
processed. The operator
only has to center the
assembly, then the tubing
and slide it into the belts.
The belts grip and carry the
assemblies through the
heating and cooling zones,
depositing them into the
unloading bin.
Safety Features:
Consistent temperatures
(ambient to 700ºC) are con-
trolled by a thermocouple
embedded into the upper
heating element connected
to a closed loop tempera-
ture controller. An alarm
light illuminates whenever
the actual heating element
temperature varies from the
• Emergency Stop
Double-sided timing belts
on either side of the upper
and lower heating cham-
bers draw the assemblies
through a thermally con-
trolled infrared heat zone,
then through a fan-cooled
zone before depositing
• Automatic cool-down
circuit to extend the life
of the components
• Over-temperature switch
that shuts off all power in
the event of an overheat
condition
Versatility
them into the unloading bin. set point temperature.
• Lockout on temperature
and speed controllers to
prevent unauthorized
changes
The processor is designed
to process a broad range of
Raychem heat-shrinkable
products up to 25 mm [1 in]
in diameter and 178 mm
[7 in] in length. The infrared
energy source is well-suited
to efficient processing of
either single wall or adhe-
sive-lined
The processor was designed
to meet the requirements
of the European Safety
Directives and is CE
approved, allowing for
worldwide use.
Speed Control
The belt speed is selected
using a 3-digit thumbwheel
(on the front panel) via a
closed loop motor controller
and DC gear motor.
Available in:
Americas
Europe
Asia Pacific
I
I
I
2-19
9-1773447-9
Dimensions are in inches and
millimeters unless otherwise
specified. Values in brackets
are metric equivalents.
Dimensions are shown for
USA: 1-800-522-6752
Germany: 49-6251-133-1999
China: 86-400-820-6015
Japan: 81-44-844-8013
CIS WR 08/2011
reference purposes only.
Specifications subject
to change.
Canada: 1-905-475-6222
Mexico: 52-55-1106-0800
te.com
L. & S. America: 54-11-4733-2200
UK: 44-800-267-666