412-18745-1
412-18745 Rev.B
6-744011-7
Attention:
Touching live parts can cause danger of electrocution with fatal consequences!
If you suspect that the tool cannot be operated safely, it must be switched off and secured against anyone
accidentally switching it on.
The tool may only be used for the purpose specified in the operating manual.
The manufacturers and suppliers will not be liable for any damages which may result due to the tool being
used for a purpose other than that for which it was intended. This is done entirely at the user’s own risk.
2.3 Notes on service and maintenance
It is absolutely essential that tool and equipment parts on which maintenance or service jobs have to be
carried out are disconnected from the electricity supply, unless anything to the contrary is stated in the
operating manual.
The disconnected parts must first be checked to ensure that they no longer carry any current; then they
must be earthed and short-circuited. Adjacent parts carrying current must be insulated.
The electrical equipment of the tool must be checked regularly, faults such as loose connections or
scorched cables must be removed immediately.
If it should be necessary to carry out work on parts which carry current, it is important to engage the
assistance of a second person who, in cases of emergency, can operate the emergency stop or the main
switch or can cut off the electricity supply to the tool. Only insulated tools should be used!
3
Special safety notes
Visually inspect all components for shipping damage. Shipping damage is not covered by warranty. If
shipping damage is found, notify carrier at once. The carrier is responsible for all repair and replacement
costs resulting from damage in shipment.
3.1 Safety
Read all instructions, warnings and cautions carefully. Follow all safety precautions to avoid personal
injury or property damage during system operation. Tyco Electronics cannot be responsible for damage
or injury resulting from unsafe product use, lack of maintenance or incorrect product and/or system
operation. Contact Tyco Electronics when in doubt as to the safety precautions and operations. Failure to
comply with the following cautions and warnings could cause equipment damage and personal injury.
A CAUTION is used to indicate correct operating or maintenance procedures and practices to prevent
damage to, or destruction of equipment or other property.
A WARNING indicates a potential danger that requires correct procedures or practices to avoid personal
injury.
A DANGER is only used when your action or lack of action may cause serious injury or even death.
WARNING: Wear proper personal protective gear when operating hydraulic equipment.
WARNING: Stay clear of loads supported by hydraulics. A cylinder, when used as a load lifting device,
should never be used as a load holding device. After the load has been raised or lowered, it must always
be blocked mechanically.
Page 17 / 26
ECOC: EGC0 ; LOC: AI
MACOM [ Tyco Electronics ]
