Absolute Maximum Ratings
Table 4ꢀ Absolute maximum ratings for LUXEON MXꢀ
PARAMETER
MAXIMUM PERFORMANCE
1500mA for L1MX-xxxx12Vxxxxx0
3000mA for L1MX-xxxx06Vxxxxx0
6000mA for L1MX-xxxx03Vxxxxx0
DC Forward Current[1, 2]
1750mA for L1MX-xxxx12Vxxxxx0
3500mA for L1MX-xxxx06Vxxxxx0
7000mA for L1MX-xxxx03Vxxxxx0
Peak Pulsed Forward Current[1, 3]
LED Junction Temperature[1] (DC & Pulse)
ESD Sensitivity (ANSI/ESDA/JEDEC JS-001-2012)
Operating Case Temperature[1]
LED Storage Temperature
135°C
Class 3B
-40°C to 120°C at 700mA for L1MX-xxxxxxxxxxxx0
-40°C to 120°C
Soldering Temperature
JEDEC 020D 250°C
Allowable Reflow Cycles
3
Reverse Voltage (Vreverse
)
LUXEON LEDs are not designed to be driven in reverse bias
Notes for Table 4:
1. Proper current derating must be observed to maintain the junction temperature below the maximum allowable junction temperature.
2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple,” are acceptable if the following conditions are met:
– The frequency of the ripple current is 100Hz or higher
– The average current for each cycle does not exceed the maximum allowable DC forward current
– The maximum amplitude of the ripple does not exceed the maximum peak pulsed forward current
3. At 10% duty cycle with pulse width of 10ms.
Operating Conditions
Drive Current
If2
If1 [mA]
4800
If2 [mA]
6000
LUXEON MX 3V
LUXEON MX 6V
LUXEON MX 12V
2400
1200
3000
1500
If1
Juncꢀon
Temperature [°C]
0
-40
120
135
Figure 1ꢀ Maximum permissible operating conditions for LUXEON MXꢀ
Notes for Figure 1:
1. The shaded area in this graph reflects the maximum permissible operating conditions for LUXEON MX.
DS179 LUXEON MX Product Datasheet 2017314 ©2017 Lumileds Holding B.V. All rights reserved.
4