Electrical and Thermal Characteristics
Table 3 . Electrical and thermal characteristics for LUXEON 3030 HV at test current, T
j
=25°C .
Part numBEr
L130- XXXXXBHV00001
L130- XXXXXCHV00001
ForWard VoltaGE
[1]
(V
f
)
mInImum
22.5
45.0
tyPIcal
24.0
48.0
maXImum
25.0
50.0
tyPIcal tEmPEraturE
coEFFIcIEnt oF ForWard
VoltaGE
[2]
(mV/°c)
-13
-26
tyPIcal tHErmal
rEsIstancE — JunctIon
to soldEr Pad (°c/W)
12
12
Notes for Table 3:
1. Lumileds maintains a tolerance of ±0.1V on forward voltage measurements.
2. Measured between 25°C and 85°C.
Absolute Maximum Ratings
Table 4 . Absolute maximum ratings for LUXEON 3030 HV .
ParamEtEr
DC Forward Current
[1,2]
Peak Pulsed Forward Current
[1,3]
LED Junction Temperature
[1]
(DC & Pulse)
ESD Sensitivity (ANSI/ESDA/JEDEC JS-001-2012)
Operating Case Temperature
[1]
LED Storage Temperature
Soldering Temperature
Allowable Reflow Cycles
Reverse Voltage (V
reverse
)
maXImum PErFormancE
60mA for L130-xxxx0BHV00001
30mA for L130-xxxx0CHV00001
80mA for L130-xxxx0BHV00001
40mA for L130-xxxx0CHV00001
125°C
Class 2
-40°C to 105°C
-40°C to 105°C
JEDEC 020D 260°C
3
LUXEON LEDs are not designed to be driven in reverse bias
Notes for Table 4:
1.
Proper current derating must be observed to maintain the junction temperature below the maximum allowable junction temperature.
2. Residual periodic variations due to power conversion from alternating current (AC) to direct current (DC), also called “ripple,” are acceptable if the following conditions are met:
– The frequency of the ripple current is 100Hz or higher
– The average current for each cycle does not exceed the maximum allowable DC forward current
– The maximum amplitude of the ripple does not exceed 25% of the maximum allowable DC forward current
3.
Pulsed operation with the maximum peak pulsed forward current is acceptable if the pulse duty cycle is ≤10%.
DS215 LUXEON 3030 HV Product Datasheet 20170110 ©2017 Lumileds Holding B.V. All rights reserved.
4
LUMILEDS [ LUMILEDS LIGHTING COMPANY ]
