LITE-ON TECHNOLOGY CORPORATION
P r o p e r t y o f L i t e - O n O n l y
Electrical / Optical Characteristics at T =25℃
A
Parameter
Luminous Intensity
Viewing Angle
Symbol
IV
Min.
2500
Typ.
7000
15
Max.
Unit
mcd
deg
nm
nm
V
Test Condition
IF = 20mA
Note 1,5
2θ
Note 2 (Fig.6)
Note 3
1/2
Dominant Wavelength
Spectral Line Half-Width
Forward Voltage
λ
525
35
d
∆λ
VF
IR
3.5
4.0
IF = 20mA
VR = 5V
Reverse Current
100
µA
NOTE: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE
eye-response curve.
2. θ1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity.
3. The dominant wavelength, λd is derived from the CIE chromaticity diagram and represents the single
wavelength which defines the color of the device.
4. Iv classification code is marked on each packing bag.
﹪
5. The Iv guarantee should be added ±15 tolerance.
6. Precautions in handling:
•
When soldering, leave 2mm of minimum clearance from the resin to the soldering point.
Dipping the resin to solder must be avoided.
Correcting the soldered position after soldering must be avoided.
In soldering, do not apply any stress to the lead frame particularly when heated.
When forming a lead, make sure not to apply any stress inside the resin.
Lead forming must be done before soldering.
It is necessary to cut the lead frame at normal temperature.
•
•
•
•
•
•
7. Caution in ESD:
Static Electricity and surge damages the LED. It is recommend to use a wrist band or anti-electrostatic
glove when handling the LED. All devices, equipment and machinery must be properly grounded.
Part No. : LTL2P3TGK
BNS-OD-C131/A4
Page :
3
of
10
LITEON [ LITE-ON TECHNOLOGY CORPORATION ]
