LTC1470/LTC1471
TYPICAL PERFORMANCE CHARACTERISTICS
5V Switch Resistance
OUTPUT VOLTAGE (V) INRUSH CURRENT (A)
OUTPUT VOLTAGE (V) INRUSH CURRENT (A)
0.30
0.25
0.20
0.15
0.10
0.05
0
0
25
50
75
100
JUNCTION TEMPERATURE (°C)
125
1470/71 G06
PROGRAMMED
TO 5V
5V SWITCH RESISTANCE (Ω)
PIN FUNCTIONS
LTC1470
OUT (Pins 1, 8):
Output Pins. The outputs of the LTC1470
are switched between three operating states: OFF, 3.3V
and 5V. These pins are protected against accidental short
circuits to ground by SafeSlot current limit circuitry which
protects the socket, the card, and the system power
supplies against damage. A second level of protection is
provided by thermal shutdown circuitry which protects
both switches against over-temperature conditions.
5V
IN
(Pin 2):
5V Input Supply Pin. The 5V
IN
supply pin
serves two purposes. The first purpose is as the power
supply input for the 5V NMOS switch. The second purpose
is to provide power for the input, gate drive, and protection
circuitry for both the 3.3V and 5V V
CC
switches. This pin
must therefore be continuously powered.
EN1, EN0 (Pins 3, 4):
Enable Inputs. The two V
CC
Enable
inputs are designed to interface directly with industry
standard PCMCIA controllers and are high impedance
CMOS gates with ESD protection diodes to ground, and
should not be forced below ground. Both inputs have
about 100mV of built-in hysteresis to ensure clean switch-
ing between operating modes. The LTC1470 is designed
to operate
without
12V power. The gates of the V
CC
NMOS
switches are powered by charge pumps from the 5V
IN
supply pins (see Applications Information section for
more detail). The Enable inputs should be turned off (both
asserted high or both asserted low) at least 100µs before
the 5V
IN
power is removed to ensure that both V
CC
NMOS
switch gates are fully discharged and both switches are in
the high impedance mode.
GND (Pin 5):
Ground Connection.
3V
IN
(Pins 6, 7):
3V Input Supply Pins. The 3V
IN
supply
pins serve as the power supply input for the 3.3V switches.
These pins do not provide any power to the internal control
circuitry and therefore do not consume any power when
unloaded or turned off.
4
U W
(LTC1470 or 1/2 LTC1471)
Inrush Current (5V Switch)
3
2
1
0
C
OUT
= 150µF
R
OUT
= 10Ω
6
4
2
0
– 0.2
0
0.2
0.4 0.6 0.8
TIME (ms)
1.0
1.2 1.4
1470/71 G08
Inrush Current (3.3V Switch)
3
2
1
0
C
OUT
= 15µF
R
OUT
= 6.6Ω
6
4
2
0
– 0.2
0
0.2
C
OUT
= 150µF
R
OUT
= 6.6Ω
0.4 0.6 0.8
TIME (ms)
1.0
1.2 1.4
1470/71 G09
T
J
= 25°C
C
OUT
= 150µF
R
OUT
= 6.6Ω
CURRENT
LIMITED
T
J
= 25°C
C
OUT
= 15µF
R
OUT
= 10Ω
U
U
U
LINER [ LINEAR TECHNOLOGY ]
