LT1207
W
W
SI PLIFIED SCHE ATIC
+
V
TO ALL
CURRENT
SOURCES
Q5
Q10
Q2
D1
Q11
Q6
Q15
Q18
Q1
Q17
Q9
–
–
V
1.25k
50Ω
COMP
V
C
C
+IN
–IN
R
C
OUTPUT
+
V
SHUTDOWN
+
V
Q12
Q3
Q8
Q16
Q14
D2
Q4
Q13
Q7
–
V
LT1207 • SS
1/2 LT1207 CURRENT FEEDBACK AMPLIFIER
O U
W
U
PPLICATI
A
S I FOR ATIO
The LT1207 is a dual current feedback amplifier with high
output current drive capability. The device is stable with
large capacitive loads and can easily supply the high
currents required by capacitive loads. The amplifier will
drive low impedance loads such as cables with excellent
linearity at high frequencies.
line when the response has 0.5dB to 5dB of peaking. The
curves stop where the response has more than 5dB of
peaking.
For resistive loads, the COMP pin should be left open (see
section on capacitive loads).
Capacitive Loads
Feedback Resistor Selection
Each amplifier in the LT1207 includes an optional com-
pensation network for driving capacitive loads. This net-
work eliminates most of the output stage peaking associ-
ated with capacitive loads, allowing the frequency re-
sponse to be flattened. Figure 1 shows the effect of the
network on a 200pF load. Without the optional compensa-
tion, there is a 5dB peak at 40MHz caused by the effect of
the capacitance on the output stage. Adding a 0.01µF
bypass capacitor between the output and the COMP pins
connectsthecompensationandcompletelyeliminatesthe
peaking. A lower value feedback resistor can now be used,
resulting in a response which is flat to 0.35dB to 30MHz.
The optimum value for the feedback resistors is a function
of the operating conditions of the device, the load imped-
ance and the desired flatness of response. The Typical AC
Performance tables give the values which result in the
highest 0.1dB and 0.5dB bandwidths for various resistive
loads and operating conditions. If this level of flatness is
not required, a higher bandwidth can be obtained by use
of a lower feedback resistor. The characteristic curves of
Bandwidth vs Supply Voltage indicate feedback resistors
for peaking up to 5dB. These curves use a solid line when
the response has less than 0.5dB of peaking and a dashed
8
Linear [ Linear ]
