LT1016
UltraFast Precision
10ns Comparator
FEATURES
■
■
■
■
■
■
■
DESCRIPTIO
UltraFast
TM
(10ns typ)
Operates Off Single 5V Supply or
±5V
Complementary Output to TTL
Low Offset Voltage
No Minimum Input Slew Rate Requirement
No Power Supply Current Spiking
Output Latch Capability
The LT
®
1016 is an UltraFast 10ns comparator that inter-
faces directly to TTL/CMOS logic while operating off either
±5V
or single 5V supplies. Tight offset voltage specifica-
tions and high gain allow the LT1016 to be used in
precision applications. Matched complementary outputs
further extend the versatility of this comparator.
A unique output stage provides active drive in both direc-
tions for maximum speed into TTL/CMOS logic or passive
loads, yet does not exhibit the large current spikes found
in conventional output stages. This allows the LT1016 to
remain stable with the outputs in the active region which,
greatly reduces the problem of output “glitching” when the
input signal is slow moving or is low level.
The LT1016 has a LATCH pin which will retain input data
at the outputs, when held high. Quiescent negative power
supply current is only 3mA. This allows the negative
supply pin to be driven from virtually any supply voltage
with a simple resistive divider. Device performance is not
affected by variations in negative supply voltage.
Linear Technology offers a wide range of comparators in
addition to the LT1016 that address different applications.
See the Related Parts section on the back page of the data
sheet.
APPLICATIO S
■
■
■
■
■
■
■
■
■
High Speed A/D Converters
High Speed Sampling Circuits
Line Receivers
Extended Range V-to-F Converters
Fast Pulse Height/Width Discriminators
Zero-Crossing Detectors
Current Sense for Switching Regulators
High Speed Triggers
Crystal Oscillators
, LTC and LT are registered trademarks of Linear Technology Corporation.
UltraFast is a trademark of Linear Technology Corporation.
TYPICAL APPLICATION
10MHz to 25MHz Crystal Oscillator
5V
2k
22Ω
820pF
10MHz TO 25MHz
(AT CUT)
5V
V
IN
100mV STEP
5mV OVERDRIVE
THRESHOLD
+
2k
V
+
Q
LT1016
Q
V
–
GND
LATCH
2k
1016 TA1a
–
OUTPUT
V
OUT
1V/DIV
200pF
0
U
Response Time
THRESHOLD
0
20
TIME (ns)
20
1016 TA2b
U
U
1
LINER [ LINEAR TECHNOLOGY ]
