Data Sheet
GE
ESTW015A0A Barracuda™ Series; DC-DC Converter Power Modules
36-75Vdc Input; 5.0Vdc, 15A, 75W Output
5.11 5.0 (100 4) 511
Feature Descriptions (continued)
Rtrim up
10.22
1.225 4
4
Output Voltage Programming
Rtrimup 404.3
Trimming allows the output voltage set point to be
increased or decreased from the default value; this is
accomplished by connecting an external resistor between
the TRIM pin and either the VO(+) pin or the VO(-) pin.
The voltage between the VO(+) and VO(–) terminals must not
exceed the minimum output overvoltage protection value
shown in the Feature Specifications table. This limit includes
any increase in voltage due to remote-sense compensation
and output voltage set-point adjustment trim.
VIN(+)
VO(+)
VOTRIM
VO(-)
Rtrim-up
Although the output voltage can be increased by both the
remote sense and by the trim, the maximum increase for
the output voltage is not the sum of both. The maximum
increase is the larger of either the remote sense or the trim.
The amount of power delivered by the module is defined as
the voltage at the output terminals multiplied by the output
current. When using remote sense and trim, the output
voltage of the module can be increased, which at the same
output current would increase the power output of the
module. Care should be taken to ensure that the maximum
output power of the module remains at or below the
ON/OFF
LOAD
Rtrim-down
VIN(-)
Figure 12. Circuit Configuration to Trim Output Voltage.
maximum rated power (Maximum rated power = VO,set
IO,max).
x
Connecting an external resistor (Rtrim-down) between the TRIM
pin and the VO(-) (or Sense(-)) pin decreases the output
voltage set point. To maintain set point accuracy, the trim
resistor tolerance should be ±1.0%.
The following equation determines the required external
resistor value to obtain a percentage output voltage change
of ∆%
511
Rtrim down
10.22
%
5.0V V
5.0V
Where
desired
%
100
For example, to trim-down the output voltage of the module
by 6% to 4.7V, Rtrim-down is calculated as follows:
% 6
511
6
Rtrimdown
10.22
Rtrim down 74.9
Connecting an external resistor (Rtrim-up) between the TRIM
pin and the VO(+) (or Sense (+)) pin increases the output
voltage set point. The following equation determines the
required external resistor value to obtain a percentage
output voltage change of ∆%:
5.115.0(100 %) 511
Rtrimup
10.22
1.225 %
%
V
5.0
5.0
Where
desired
%
100
For example, to trim-up the output voltage of the module by
4% to 5.2V, Rtrim-up is calculated is as follows:
% 4
March 28, 2013
©2012 General Electric Company. All rights reserved.
Page 8
LINEAGEPOWER [ LINEAGE POWER CORPORATION ]
