Dimensions DHR-C10
(in mm. 1 mm = 0.0394 inch)
25
70
60
32
4.
60
2 2.2 8
25
15
8.30
6.8 0
90
2 .50
10
40
6 .80
4
15
33 .80
4 .60
7
8.30
6
78
Connections
DHR-C5/10
•
Wires up to 2 mm
∅
•
Female connector provided
(screw terminals)
DHR
Mechanical characteristics
•
General tolerance
•
Primary aperture
•
Panel mounting
•
Distance between holes
±1 mm
∅
32.0 mm
4 holes
∅
4.6 mm
70.0 mm & 78 mm
(see above dimensions)
Output Connector
1(Vcc) 2(NC) 3(Vout) 4(GND)
24 VDC Power
(+)
(-)
For panel mounting, replace M4 screws by new one (not supplied)
with appropriate length to panel´s thickness.
Remarks
10k
(-)
(+)
Load
(Controller, meter etc)
+24VDC
Is
•
V
OUT
is positive when I
P
flows in the direction of the arrow.
•
The return busbar and primary conductor elbow must be located
at least at 2.5 x window length more far away from the transducer
case.
•
The temperature of the primary busbar can not exceed 90 °C.
•
Dynamic performances are the best with a primary busbar
completely filling the primary aperture.
•
This is a standard model. For different versions (supply voltages,
different outputs, bidirectional measurements...), please
contact us.
OUT
Ip
GND
25.60
70
Page 3/3
061128/14
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
www.lem.com