Dimensions CT 5 .. 25-T
Front view
(in mm. 1 mm = 0.0394 inch)
Left view
Connection
Top view
Mechanical characteristics
•
General tolerance
•
Transducer fastening
•
Connection of primary
•
Connection of secondary
•
Fastening torque
± 0.3 mm
2 holes M5 screws
2 steel screws M5
M5 threaded studs
M5 threaded studs
2.2 Nm or 1.62 Lb - Ft
Remarks
•
V
OUT
is positive when
I
P
flows in the direction of the arrow.
•
This transducer induces into the primary circuit a square
wave of 70 mV amplitude (frequency
≈
220 Hz). This voltage
can induce an AC current in the primary if the primary
impedance is low.
•
This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
Page 3/3
060927/0
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
w w w .lem.com
LEM [ LEM ]
