Dimensions CT 100-S (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Secondary terminals
Terminal + : supply voltage + 15 V
Terminal M : measure
Terminal 0 : 0 V
Terminal
- : supply voltage - 15 V
Connection
Top view
Mechanical characteristics
Remarks
· General tolerance
· Fastening
· Primary through-hole
· Connection of secondary
Fastening torque
± 0.3 mm
2 x M5 screws
Æ 15 mm
M5 threaded studs
2.2 Nm or 1.62 Lb - Ft
· VOUT is positive when IP flows in the direction of the arrow.
· This transducer induces into the primary circuit a square
wave of 3.5 mV amplitude (frequency » 220 Hz). This voltage
can induce an AC current in the primary if the primary
impedance is low.
· This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
LEM [ LEM ]
