Front Panel Description
1. AC On/Off
2. Air Intake allows zero stacking for maximum system flexibility and power density
3. Reliable encoder controls Output Voltage and sets Address.
4. Volt Meter shows Output Voltage and directly displays OVP, UVL and Address settings.
5. Amp Meter also displays baud rate.
6. Reliable encoder controls Output Current and sets baud rate.
7. Function/Status LED's
•
Alarm
•
Fine Control
•
Preview Settings
•
Foldback Mode
•
Remote Mode
•
Output On
8. Pushbuttons allow flexible user configuration
Coarse and Fine Voltage and Current Adjustment of Output
Preview Settings and Set Voltage while in Current Mode or with Output OFF
Set OVP and UVL Limits
Set Current Foldback
Local/Remote Mode and select Address and Baud Rate
Output ON/OFF and Auto Start/Safe Start Mode
Rear Panel Description
Remote/Local Output Voltage Sense Connections
DIP Switches select 0-5V or 0-10V Programming and other functions.
DB25 (Female) connector allows (Non-isolated) Analog Program and Monitor as well as other functions.
RS485 Out to other Genesys Power Supplies
RS232/RS485 IN Remote Serial Programming
Output Terminals are rugged bus bars for 6-60V Output, higher output voltage models have terminal block connector.
Exit air assures reliable operation when zero stacked
Wide-Range Input 85-265VAC continuous, 47/63Hz with Active Power Factor Correction (0.99)
AC Input Connector 750W: IEC320, 1500W: Screw terminal Model Shown
9. Position for Optional Isolated Analog Programming or GPIB Digital Interface model shown
1.
2.
3.
4.
5.
6.
7.
8.
|2
LAMBDA [ DENSEI-LAMBDA ]
