24 | Keysight | U4164A Logic Analyzer Module - Data Sheet
Minimum Hardware (Continued)
Chassis and controller considerations (Continued)
– There are three host PC possibilities for an AXIe chassis - M9536A embedded controller,
external laptop PC, or external desktop PC. Select one of the host PC configurations above
for your U4164A system
– If you’re using a laptop or desktop PC, see 5990-7632EN for a list of tested computers
– An M9505A 5-slot chassis is required when using a U4164A three-module set or a U4164A
two-module set when used with an M9536A embedded controller as the M9536A is
installed in the bottom slot (slot 1) of the chassis
– Version 6.20 or higher of the logic and protocol analyzer software needs to be installed
on the host PC. Refer to the software download site for the latest supported operating
systems
Cables
Up to four U4201A logic analyzer cables may be required per U4164A module depending on
probing method. See probing chart for details. Interposers with direct connect cabling, such as
the FuturePlus FS2510AB DDR4 DIMM interposer, do not require additional U4201A cables.
Typical Configurations
M9505A AXIe
5 slot chassis
U4164A logic analyzer modules (qty 3)
with Option 02G on all modules
FS2510AB DDR4
DIMM interposer
with direct connect
cabling to U4164A
M9536A embedded
controller
Figure 14. Typical configuration for DDR4 DIMM debug and validation for data rates greater 2500 Mb/s.
Recommended configuration for DDR4 DIMM solution over 2.5 Gb/s data rates
Model
Quantity Description
U4164A
3
Logic analyzer module, 136 channel, 12.5 GHz TZ, 5 GHz timing, 350 MHz
base state speed, 2 Mb
U4164A-02G
M9505A
M9536A
FS2510AB with
FS1070
3
1
1
Increase maximum speeds: state to 4 Gb/s (2.5 GHz) and timing to 10 GHz
AXIe 5 slot chassis
AXIe Embedded controller or M9045B or M9048A PCI Express® adaptors
DDR4 DIMM interposer from FuturePlus Systems. Available through
Keysight
Note: M9536A controller, if used, must be installed in slot 1.
KEYSIGHT [ Keysight Technologies ]
