Measurement Requꢀrements
To use the N5392B Energy Efficient
Ethernet electrical performance
validation and conformance software
on your Infiniium oscilloscope,
you will need oscilloscope probes,
probe heads, Wilder Technologies
Energy Efficient Ethernet electrical
conformance test fixture and other
test accessories depending on the
Ethernet standard and test suites you
want to perform. For 10BASE-T and
100BASE-TX Ethernet testing, the
test configurations are similar. For
1000BASE-T, the testing requirements
include SMA cables.
Wꢀlder Technologꢀes EEE-
TPA-ERK Energy Eficꢀent
Ethernet electrical confor-
mance test ixture kꢀt
The Wilder Technologies EEE-
TPA-ERK Energy Efficient Ethernet
electrical conformance test fixture
kit includes a main test fixture board,
two short RJ-45 interconnect cable,
and fourteen 50 ohm termination
plugs. The main test fixture board is
subdivided into four sections that are
configured specifically for the require-
ments of different tests. Ethernet
device connection is accomplished
through the short RJ 45 interconnect
cable.
The following section describes the
fixtures and tests.
Some measurements require a direct
SMA cable connection to channels
on the oscilloscope, however, most
commonly the connection is via a
Keysight InfiniiMax active differential
probe (1130A, 1131A, 1132A, 1134A,
1168A, or 1169A) with an E2678A
socketed differential probe head.
13
KEYSIGHT [ Keysight Technologies ]
