欢迎访问ic37.com |
会员登录 免费注册
发布采购

N5384A-1TP 参数 Datasheet PDF下载

N5384A-1TP图片预览
型号: N5384A-1TP
PDF下载: 下载PDF文件 查看货源
内容描述: [Infiniium S-Series High-Definition Oscilloscopes]
分类和应用:
文件页数/大小: 42 页 / 4513 K
品牌: KEYSIGHT [ Keysight Technologies ]
 浏览型号N5384A-1TP的Datasheet PDF文件第7页浏览型号N5384A-1TP的Datasheet PDF文件第8页浏览型号N5384A-1TP的Datasheet PDF文件第9页浏览型号N5384A-1TP的Datasheet PDF文件第10页浏览型号N5384A-1TP的Datasheet PDF文件第12页浏览型号N5384A-1TP的Datasheet PDF文件第13页浏览型号N5384A-1TP的Datasheet PDF文件第14页浏览型号N5384A-1TP的Datasheet PDF文件第15页  
11 | Keysight | Infiniium S-Series High-Definition Oscilloscopes - Data Sheet  
Oscilloscope Overview – Frequency Domain (Continued)  
Trying to interpret traditional oscilloscope time-domain specifications can be challenging in determining if a specific scope can  
be recommended for RF/uW/mmW measurements. With correction filters, low-noise front end, and the 10-bit ADC, S-Series  
oscilloscopes can be used for wideband RF applications. Typical RF characteristics for the S-Series are listed below with graphs  
showing characterization results shown at the bottom of the page.  
Typical RF characteristic values from measured results on an 8-GHz S-Series oscilloscope  
Sensitivity/noise density  
—160 dBm/Hz  
1 mV/div; —38 dBm range  
Power spectral density measurement at 1.0001 GHz, 1.0001 GHz center frequency, 500 kHz span, and 3 kHz RBW  
Noise figure  
14 dB  
Derived from measurement above  
Signal-to-noise ratio/dynamic range  
108 dB  
0 dBm 1 GHz input carrier, 0 dBm scope input range  
1 GHz center frequency, 100 MHz span, 1 kHz RBW, measurement at +20 MHz from center  
Absolute amplitude accuracy  
± 1 dB  
0 to 7.5 GHz  
Deviation from linear phase  
± 7 deg  
0 to 7.5 GHz  
Phase noise (at 1 GHz)  
10 kHz offset  
100 kHz offset  
EVM  
—121 dBc/Hz  
—122 dBc/Hz  
—47 dB (0.47%)  
802.121 2.4 GHz carrier, 20 MHz wide, 64 QAM  
Spurious responses (0 dBm signal, 0 dBm input range)  
Spur Free Dynamic Range (SFDR)  
1 GHz, 0 dBm signal present at input, FFT =5 GHz span, 3 GHz center, 100 kHz RBW  
2nd harmonic distortion  
72 dB  
1 GHz input, 0 dBm, 5 GHz span, 3 GHz center, 100 KHz RBW  
3rd harmonic distortion  
—64 dBc  
1 GHz input, 0 dBm, 5 GHz span, 3 GHz center, 100 KHz RBW  
Two-tone Third-Order Intermodulation (TOI) distortion  
0 dBm input tones, 2.435 GHz and 2.439 GHz, 2 MHz separation, 2.437 GHz center frequency, 10 MHz span, 100 kHz  
RBW, 6 dBm input range  
—46 dBc  
+21.5 dB  
Input match  
< 50 mV/div, 0-7 GHz  
>= 50 mV/div, 0-7 GHz  
—15 dB; 1.4 VSWR  
—19 dB; 1.25 VSWR  
Using data acquired from S-Series, VSA shows an excellent TOI value of  
21.5 dB.  
Using data acquired from S-Series, VSA shows an EVM for IEEE 802.11  
QAM 64 of 0.47%.  
 复制成功!