10 | Keysight | M9336A I/Q Arbitrary Waveform Generator - Data Sheet
Technical Specifications
Analog Outputs
Characteristic 1
Amplitude resolution
16-bit
Amplitude DC accuracy
±0.5% of setting ±5 mV
Jitter 5
Fc = 10 MHz
Fc ≥ 50 MHz
<1 ps rms
<0.25 ps rms
Rise/fall time (10% to 90%)
Without corrections
With corrections
<1.2 ns, typical
<900 ps, typical
Single-ended output characteristics 1
Characteristic
Channels 1 & 2
Channel 3
Nominal output impedance
Nominal amplitude range 2, 4
Without corrections
With corrections 3
Offset
50 ohm
50 ohm
0 Vpp to 1 Vpp
0 Vpp to 0.8 Vpp
0 Vpp to 1.65 Vpp
0 Vpp to 1.26 Vpp
Range
-0.3 to +0.81 V
100 uV
±1.2 V
Adjustment resolution
Analog gain
100 uV
Range
15 dB (min=0.11, max=0.66)
0.0001
15 dB (min=0.18, max=1.08)
0.0001
Adjustment resolution
Digital gain
Range
min=0, max=1
0.0001
min=0, max=1
0.0001
Adjustment resolution
1. Each output terminated with 50 ohms to ground.
2. With maximum analog and default digital gain settings. Higher levels of digital gain are possible depending on signal type. For example, channels 1 and 2
can output a with a 1.3 Vpp sinewave. Using maximum digital gain on complex waveforms with high crest factors may cause signal overload.
3. At maximum sample rate. Reducing sample rate will allow for higher amplitude settings.
4. For channel 3, it is recommended to keep (Vpp X Frequency) <2.5x108 and offsets = 0V to minimize harmonic distortion. If offsets are used, it is recommend-
ed to keep (Vp X Frequency) <4x107
5. 1 kHz to 10 MHz integration bandwidth