04 | Keysight | M9005A PXIe Chassis - Data Sheet
Software Overview
The M9005A provides a simple use model. The only necessary software is low level
chassis driver which allows the system PXI resource manager to enumerate the M9005A
chassis and the installed modules.
Keysight Standard Warranty
With Keysight’s standard warranty, your investment is protected by Keysight’s global
reach in more than 100 countries (either directly or through distributors). The warranty
gives you convenient standard coverage for the country in which the product is used,
eliminating the need to ship equipment back to the country of purchase. Keysight’s
warranty service provides:
– All parts and labor necessary to return your investment to full specified
performance
– Recalibration for products supplied originally with a calibration certificate
– Return shipment
Definitions
Specifications
Warranted performance. Specifications include guardbands to account for the expected statistical performance distribution, measurement uncertainties,
and changes in performance due to environmental conditions. All specifications and characteristics apply over the operating environment outlined in the
“Environmental and Regulatory” section of this data sheet. In addition, the following conditions must be met:
– Instrument is within its calibration cycle if calibration is required.
– Instrument has been stored for a minimum of 1 hour within the operating temperature range prior to turn-on and after a 30 minute warm-up period.
Characteristic
Characteristics describe product performance that is useful in the application of the product, but that is not covered by the product warranty.
Characteristics are often referred to as Typical or Nominal values.
Typical
Expected performance of an average unit when operated over a 20 to 30 °C temperature range. Typical performance is not warranted. The instrument
must be within its calibration cycle if calibration is required.
Nominal
Nominal describes representative performance that is useful in the application of the product when operated over a 20 to 30 °C temperature range.
Nominal performance is not warranted.
Module specifications and configuration
Some module specifications may be affected by chassis characteristics. Refer to module datasheet to determine the configuration used when
specifications were set and to ensure module power and cooling requirements are met.
Additional information
All data are measured from multiple units at room temperature and are representative of product performance within the operating temperature range
unless otherwise noted.
The specifications contained in this document are subject to change.