02 | Keysight | M3100A PXIe Digitizer with Optional Real-Time Sequencing and FPGA Programming - Data Sheet
Improve Your Measurement Fidelity, Signal Integrity
and Measurement Throughput
The M3102A are high-performance, high-bandwidth digitizers with an advanced
data acquisition system (DAQ). Performance meets simplicity thanks to easy-to-
use programming libraries, real-time sequencing technology (HVI Hard Virtual
Instrumentation), and graphical FPGA programming technology.
Features
100 MSa/s simultaneous sampling, 14 bits, 4/8 channels, 100 MHz BW 1
Advanced data acquisition system (DAQ)
– Flexible triggering (HW trigger, HVI trigger, SW trigger)
– Programmable cycles and data bursts to avoid PC saturation
Optional HW programming for high-performance applications
– Real-time sequencing (HVI technology)
– FPGA programming
– Xilinx Kintex-7, 325T or 410T FPGA
Up to 2 GB of onboard RAM (~ 1 Gsamples)
Mechanical/interface
– 1 slot 3U (PXIe)
– Up to 1.6 GB/s transfer BW with P2P capabilities (PCIe Gen 2)
– Independent DMA channels for fast and efficient data transfer
Applications
General purpose digitizer
Hardware-in-the-loop (HIL)/automated test equipment (ATE)
R&D/scientific research equipment
Aerospace & defense (A/D)
1. 100 MHz refer to the Front End bandwidth. This digitizer can operate in 1st and 2nd Nyquist zones
(using undersampling technique), but its real-time BW is limited by Nyquist to some 50 MHz. As an
example for a band-limited signal of 70 MHz with a 10 MHz signal bandwidth the aliased component
will appear between 25 to 35 MHz (30 ± 5 MHz).