09 | Keysight | InfiniiVision 1000 X-Series Oscilloscopes - Data Sheet
Scrap the Toys, Get a Real Oscilloscope (Continued)
3� Hardware-based serial protocol decode and
triggering
4 and 5� Digital voltmeter and frequency counter
The 1000 X-Series has an integrated 3-digit voltmeter (DVM) and
5-digit frequency counter inside each oscilloscope� The voltmeter
operates through probes connected to the oscilloscope channels,
but its measurement is de-coupled from the oscilloscope
triggering system so both the DVM and triggered oscilloscope
measurements can be made with the same connection� You can
quickly measure AC RMS, DC, DC RMS and frequency without
configuring the oscilloscope capture� The voltmeter results
are always displayed, keeping these quick characterization
measurements at your fingertips� Turn on the DVM capability
for no addition cost by registering your oscilloscope at
Protocols supported
– I2C, UART/RS232 for EDU models (EDUX1EMBD)
– I2C, SPI, UART/RS232 for DSO models (DSOX1EMBD)
– CAN, LIN (automotive) for DSO models (DSOX1AUTO)
When you add optional software, the 1000 X-Series is a powerful
protocol analyzer that can do powerful decode and hardware-
based triggering that enables specialized serial communication
analysis� Other vendors’ oscilloscopes use software post-
processing techniques that slow down the waveform and decode
update rate, but the 1000 X-Series has faster decoding by using
hardware-based technology that enhances scope usability and
the probability of capturing infrequent serial communication
errors�
www.keysight.com/find/1000X-Series-DVM�
The DVM makes accurate RMS measurements when the signal frequency
is between 20 Hz and 100 kHz�