24 | Keysight | E5080A ENA Series Network Analyzer, E5092A Configurable Multiport Test Set - Data Sheet
Table 49. Control line
Description
Specification
Typical
Number of groups
4
Group A: 8 bits
Group B,C,D: 4 bits
Input voltage range1
Maximum current
Impedance
0 V to +5 V (positive input)
—5 V to 0 V (negative input)
Group A, B: 50 mA in total of each group
Group C, D: 500 uA in total of each group
Group A, B: < 10 ohm
Group C, D: < 200 ohm
Table 50. DC source
Description
Specification
Typical
Number of sources
Output voltage range
Output voltage accuracy
Voltage resolution
Maximum current
Output impedance
4
0 V to +5.2 V (nominal)2
10 mV (nominal)3
< 5 ohm
± 3 % of setting (+1 V to +5 V) at 1 M ohm load impedance
150 mA for each source
Table 51. Operating storage environment
Description
Temperature
Humidity
General characteristics
+5 °C to +40 °C
20 to 80 % at wet bulb temperature < +29 °C (non-condensing)
0 to 2,000m (0 to 6,561 feet)
0.21 G max., 5 to 500 Hz
Altitude
Vibration
Table 52. Non-operating storage environment
Description
Temperature
Humidity
General characteristics
—10 °C to +60 °C
20 to 90 % at wet bulb temperature < +40 °C (non-condensing)
0 to 4,572 m (0 to 15,000 feet)
0.5 G max., 5 Hz to 500 Hz
Altitude
Vibration
Table 53. Front panel information
Description
General characteristics
SMA (female)
RF connectors
Test ports
38 ports
Control line
15-pin D-sub, female
25-pin D-sub, female
1. Input voltage will be clipped at about ± 5.2 V when over this range.
2. The output voltage can be set in this range.
3. The output voltage resolution becomes effective between 0 V to 5.2 V.