09 | Keysight | E4990A Impedance Analyzer 20 Hz to 10/20/30/50/120 MHz - Data Sheet
Measurement Time (continued)
Measurement frequency [Hz]
Figure 4. Measurement time (Option 050/ 030/ 020/ 010 without option 001, Typical)
Adapter Setup
Adapter selection
NONE
No adapter (the 16047E, etc. direct connection type test fixture is connected)
4TP 1M
Four-terminal pair 1 m (16048G)
Four-terminal pair 2 m (16048H)
Terminal adapter (42942A)
4TP 2M
7-mm 42942A1
Probe 42941A1
Impedance probe (42941A)
1. Option 120 only.
Calibration
Calibration
User calibration
Port extension
Calibration performed with user-defined calibration kit (OPEN, SHORT, LOAD)
Compensation performed when the measurement terminal is expanded from the 7-mm connector of the
42942A Terminal Adapter or the test port of the 42941A Impedance Probe. Enter electrical length or delay time
for the extension.
Fixture compensation
Calibration points
Compensation performed at the device contacts of the test fixture using OPEN, SHORT, LOAD.
Fixed points, or User points determined by sweep setups