37 | Keysight | Infiniium S-Series High-Definition Oscilloscopes - Data Sheet
Infiniium S-Series Performance Characteristics (Continued)
Trigger
Trigger: digital channels MSO models
Threshold range (user defined)
Threshold accuracy
± 8.0 V in 10-mV increments
± (100 mV + 3% of threshold setting)
Trigger modes
Edge (analog and digital)
Triggers on a specified slope (rising, falling or alternating between rising and falling) and voltage level on
any channel
Edge transition (analog)
Trigger on rising or falling edges that cross two voltage levels in > or < the amount of time specified.
Edge transition setting from 250 ps
Edge then edge (time) (analog and digital)
Edge then edge (event) (analog and digital)
Glitch (analog and digital)
Pulse width (analog and digital)
1 GHz and 500 MHz model
2 GHz and 2.5 GHz model
4 GHz, 6 GHz, 8 GHz model
Runt (analog)
The trigger is qualified by an edge. After a specified time delay between 10 ns to 10 s, a rising or falling
edge on any one selected input will generate the trigger
The trigger is qualified by an edge. After a specified delay between 1 to 16,000,000 rising or falling
edges, another rising or falling edge on any one selected input will generate the trigger
Triggers on glitches narrower than the other pulses in your waveform by specifying a width less than
your narrowest pulse and a polarity. Glitch range settings equal pulse width settings
Trigger on a pulse that is wider or narrower than specified. Pulse width range setting is 250 ps to 10 s for
analog channels and 2 ns to 10 s for digital channels
Minimum detectable pulse width
Minimum detectable pulse width
Minimum detectable pulse width
150 ps for analog channels
1 ns for digital channels
100 ps for analog channels
1 ns for digital channels
50 ps for analog channels
1 ns for digital channels
Triggers on a pulse that crosses one threshold but fails to cross a second threshold before crossing the
first again. Runt settings equal pulse width settings
Timeout (analog and digital)
Pattern/pulse range
Trigger when a channel stays high, low, or unchanged for too long
Timeout settings equal pulse width settings
Triggers when a specified logical combination of the channels is entered, exited, present for a (analog
and digital)
Specified period of time or is within a specified time range or times out. Each channel can have a value of
High (H), Low (L) or Don’t care (X)
State (analog and digital)
Setup/hold (analog)
Pattern trigger clocked by the rising, falling or alternating between rising and falling edge of one
channel.
Triggers on setup, hold, or setup and hold violations in your circuit. Requires a clock and data signal on
any two inputs (except aux or line) channels as trigger sources. Setup and/or hold time must then be
specified.
Window (analog)
Protocol packets (hardware serial trigger)
Zone-qualified
Trigger on entering, exiting, or inside specified voltage range
Requires specified protocol option, I2C, SPI, CAN, LIN, RS-232/UART, SVID, USB, PCIe® Gen 1
Requires InfiniiScan software option. SW-based triggering across up to 8 user-drawn zones. For each
zone, user specifies “must intersect” or “must not intersect.” Zones can be drawn on multiple channels
and combined using Boolean expressions
KEYSIGHT [ Keysight Technologies ]
