35 | Keysight | InfiniiVision 6000 X-Series Oscilloscopes - Data Sheet
Performance Characteristics (Continued)
Trigger system
Trigger jitter
< 1.0-ps rms with the jitter-free trigger
< 3.0-ps rms without the jitter-free trigger
Trigger bandwidth
Edge
Other modes
1 GHz bandwidth
500 MHz, 1 GHz, 2.5 GHz models: bandwidth of oscilloscope. 4-GHz and 6-GHz models: 3.5 GHz
Bandwidth of oscilloscope or 1 GHz, whichever is smaller
Trigger sensitivity
(internal) 1
≤ 10 mV/div
> 10 mV/div
≤ 10 mV/div
DC to 1 GHz
DC to 1 GHz
DC to 2 GHz
2.0 to 3.5 GHz
DC to 2 GHz
2.0 to 3.5 GHz
Greater of 1 div or 5 mVpp
0.6 div
Greater of 1 div or 5 mVpp
Greater of 1.5 div or 5 mVpp
0.6 div
2.5, 4, and 6 GHz
bandwidth
> 10 mV/div
1.0 div
Trigger sensitivity
(external) 1
Trigger level range
± 1.6 V
± 8 V
Any channel
External
40 mVpp DC to 100 MHz, 70 mVpp 100 to 200 MHz
200 mVpp DC to 100 MHz, 350 mVpp 100 to 200 MHz
± 6 div from center screen
8-V range = ± 8 V; 1.6-V range = ± 1.6 V
1. Denotes warranted specifications; All others are typical. Specifications are valid after a 30-minute warm-up period and ± 10 °C from firmware calibration
temperature.
Trigger type selections
InfiniiScan Zone (hardware zone qualifier)
Trigger on user-defined zones drawn on the display. Applies to one analog channel at a time.
Specify zones as either “must intersect” or “must not intersect.” Up to two zones. > 160,000 wfm/
sec update rate
Supported modes: Normal, peak detect, high resolution, max update rate
Also works simultaneously with the serial decodes and mask/limit test
Trigger on a rising and falling edge of any source, alternating or either edge of analog and digital
channels
Edge
Edge then edge (B trigger)
Pulse width
Arm on a selected edge, wait a specified time, then trigger on a specified count of another selected
edge. Minimum 4 ns
Trigger on a pulse on a selected channel, whose time duration is less than a value, greater than a
value, or inside a time range
– Minimum duration setting: 2 ns
– Maximum duration setting: 10 s
– Range minimum: 10 ns
Pattern
Trigger when a specified pattern of high, low, and don’t-care levels on any combination of analog,
digital, or trigger channels is [entered | exited]. Pattern must have stabilized for a minimum of 2 ns to
qualify as a valid trigger condition
– Minimum duration setting: 2 ns
– Maximum duration setting: 10 s
Or
Trigger on any selected edges from available sources (analog and digital channels only).
Bandwidth is 500 MHz
KEYSIGHT [ Keysight Technologies ]
