08 | Keysight | InfiniiVision 6000L Series Low-Profile Oscilloscopes - Data Sheet
Performance characteristics
Scope input
Channels
Ch 1, 2, 3 and 4 simultaneous acquisition
Bandwidth (–3 dB)*
DSO6014L: DC to 100 MHz
DSO6054L: DC to 500 MHz
DSO6104L: DC to 1 GHz
Maximum input
Full Scale range1
Input impedance
CAT I 300 Vrms, 400 Vpk, CAT II 100 Vrms, 400 Vpk
With 10073C/10074C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
5 Vrms with 50 Ω input
DSO6014L: 1 mV/div to 5 V/div (1 MΩ)
DSO6054L: 2 mV/div to 5 V/div (1 MΩ or 50 Ω)
DSO6104L: 2 mV/div to 5 V/div (1 MΩ), 2 mV/div to 1 V/div (50 Ω)
DSO6014L2: 1 MΩ 1% ꢀꢀ 11pF
DSO6054L/6104L: 1 MΩ 1% ꢀꢀ 14pF or 50 Ω 1.5%, selectable
Coupling
AC, DC
Offset range
5 V on ranges < 10 mV/div
25 V on ranges 10 mV/div to 200 mV/div
75 V on ranges ≥ 200 mV/div
Connector
BW limit
BNC
DSO6014L: 20MHz
DSO6054L/6104L: 25 MHz selectable
Noise peak-to-peak
DSO6014L: 3% full scale or 2 mV, whichever is greater
DSO6054L: 3% full scale or 3.6 mV, whichever is greater
DSO6104L: 3% full scale or 4.5 mV, whichever is greater
DC Vertical
*
Denotes warranted specifications, all others are typical. Specifications are valid after a 30-minute warm-up period and 10 ꢁC from firmware calibration temperature.
1
2
1 mV/div is a magnification of 2 mV/div. 2 mV/div is a magnification of 4 mV/div setting. For vertical accuracy calculations, use full scale of 16 mV for 1 mV/div sensitivity
setting and 32 mV for 2 mV/div sensitivity setting.
Four 50 Ω termination adapters are supplied with DSO6014L.
Logic channels (with MSO option)
Number of channels
Maximum input frequency
Sample rate
16 logic timing channels – labeled D15 - D0
250 MHz
2 GSa/sec one pod*, 1 GSa/sec each pod
Memory depth
1 pod /both pod
8 Mpts/4 Mpts
Standard memory
Vertical resolution
Threshold selections
Maximum input voltage
Glitch detection
1 bit
TTL, CMOS, ECL, user-definable (selectable by pod)
40 V peak CAT I
2 ns (min pulse width)
* A pod is a group of 8 digital channels. either 0-8 or 9-16
KEYSIGHT [ Keysight Technologies ]
