2745 SERIES
User Safety
Safety and Operating Considerations
The laser light emitted from this diode laser is invisible and may be harmful to the human eye. Avoid looking directly into the
fiber when the device is in operation.
CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT INCREASES EYE HAZARD.
Operating the diode laser outside of its maximum ratings may cause device failure or a safety hazard. Power supplies used with
this component cannot exceed maximum peak optical power.
CW diode lasers may be damaged by excessive drive current or switching transients. When using power supplies, the diode
laser should be connected with the main power on and the output voltage at zero. The current should be increased slowly while
monitoring the diode laser output power and the drive current. Careful attention to heatsinking and proper mounting of this
device is required to ensure specified performance over its operating life. To maximize thermal transfer to the heatsink, the
heatsink mounting surface must be flat to within .001”, and the mounting screws must be torqued down to 1.5 in.-lb.
ESD PROTECTION — ESD is the primary cause of unexpected diode laser failure. Take extreme precaution to prevent ESD.
Use wrist straps, grounded work surfaces, and rigorous antistatic techniques when handling diode lasers.
Labeling
21 CFR 1040.10 Compliance
Because of the small size of these
devices, the output power and laser
emission indicator label shown below is
attached to the individual shipping
container. All labels are illustrated here
to comply with 21 CFR 1040.10 as
applicable under the Radiations Control
for Health and Safety Act of 1968.
14-Pin Module Label
08/18/08 27-ABC123
27-xxxx-xxx-45
Made in China
Shipping Box Label
27-ABC123
Model:
27-xxxx-xxx-45
JDS Uniphase (Shenzhen) Ltd
3 Hongmian Road
Futian Free Trade Zone
Shenzhen, China 518038
Made in China
Output Power and Laser Emission Indicator Label
DANGER
INVISIBLE LASER RADIATION -
AVOID DIRECT EXPOSURE TO BEAM
PEAK POWER 500 mW
WAVELENGTH 630 - 1,550 nm
CAUTION -
Handle with care. Easily damaged
by electrostatic discharge
INVISIBLE
LASER DIODE
AVOID EXPOSURE
This product complies with 21 CFR Chapter 1, Subchapter J
CLASS 3B LASER PRODUCT
Visible/invisible
radiation emitted
from fiber end or
fiber receptacle
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
2745PUMP.DS.CC.AE
March 2009
Product specifications and descriptions in this document subject to change without notice. © 2009 JDS Uniphase Corporation 30162502 001 0309
PureMode is a registered trademark of Corning Incorporated. Telcordia is a registered trademark of Telcordia Technologies Incorporated.
08/18/08
Serial:
JDSU [ JDS UNIPHASE CORPORATION ]
