RF Coaxial Connectors
Assembly Instructions
BBAI NO.: 1293 1.0/2.3 Solder crimp Right Angle Jack
Tools Required:
Locator:
Crimp Tool: see instruction 5
1. Trim cable to the dimensions shown, being careful not to damage the braid, dielectric, foil
or inner conductor.
C
jacket
D
E
+0.00 (+.000)
-0.20 (- .008)
+0.00 (+.000)
-0.50 (- .019)
+0.20 (+.008)
-0.00 (- .000)
Stripping Detail
C
D
E
dielectrics
A
B
11.00 (.433)
12.50 (.492)
5.00 (.197)
5.00 (.197)
3.00 (.118)
3.00 (.118)
(*) 1 max
(.039)
center
conductor
braids
For cables with a foil under the braid, spread braid and trim back to dimensions shown.
The foil should be left in place over the dielectric.
(*) Trim the intermediate foil to the
indicated dimension
2. If fitted, remove the cap from the body of the connector.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help) and ensure that the conductor fits into the slot in the rear
of the contact.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Die Part
Number
K29265
K29263
T1025/9
K29263
Cable
Type
BT 3002
ST214
ST 212
RG 179 B/U
Die
Size
4.30 (.170)
3.25 (.128)
3.80 (.151)
3.25 (.128)
Stripping
Detail
A
A
A
A
Dimensions are shown in mm (inch)
Dimensions subject to change
31
www.ittcannon.com