C&K 3 Series
Thumbwheel Switches
TERMINATIONS
0
TYPE 0
1
TYPE 1, EXTENDED TYPE 0
N
SOLDER PINS WITH .100” SPACING
Signal traces cut except for common(s).
9
ANY COMBINATION OF TERMINATION
CONFIGURATIONS OR SPECIAL TERMINATIONS.
Specify on configuration form, page N–15
and consult Customer Service Center.
P
SOLDER PINS WITH .156” SPACING
PC Board 1/32" (0,79) thick.
NOTE:
All terminal holes shown may not be present for all function codes, consult Customer Service Center.
Terminal connector available for termination options 0 & 1, see page N–14.
NOTE:
Termination option N (RoHS compliant) replaced termination option 3 (Non-RoHS compliant).
Termination option P (RoHS compliant) replaced termination option B (Non-RoHS compliant).
Thumbwheel & Pushwheel
Terminal Location Numbers
FIG. 1
NOTE:
See function codes, pages N–9 and N–10, for signal locations.
FIG. 2
COLOR/MARKING/STOPS
0
MATTE BLACK HOUSING (Gloss black wheel with white characters; no stops.)
NOTE:
Stop pins are available separately, see page N–14.
SEAL
N
0
1
2
3
UNSEALED SWITCHING CONTACTS.
SEALED SWITCHING CONTACTS. (Sealing is by means of an o-ring rotary seal and a cured-in-place elastomer gasket.
Switching contact area is protected from moisture, oil, and airborne contaminants.)
DUST LENS. (Protects the character face of the wheel from abrasion and dirt).
SEALED SWITCHING CONTACTS AND DUST LENS
Dust Lens
Dimensions are shown: Inch (mm)
Specifications and dimensions subject to change
N–12
www.ittcannon.com
ITT [ ITT INDUSTRIES ]
