Crane Aerospace & Electronics Power Solutions
FMD28-461 eMi input Filters
28 Volt input – 7 aMp
S
TANDARD AND
/ES (
NON
-QML) P
RODUCTS
E
NVIRONMENTAL
S
CREENING 1
test perFOrmed
Pre-cap Inspection
Method 2017, 2032
Temperature Cycle (10 times)
Method 1010, Cond. B, -55°C to +125°C, ambient
Constant Acceleration
Method 2001, 500 g
Burn-in
Method 1015
3
96 hours
Final Electrical Test MIL-PRF-38534, Group A
Subgroups 1 and 4: +25°C case
Hermeticity Test
Fine Leak, Method 1014, Cond. A
Gross Leak, Method 1014, Cond. C
Gross Leak, Dip (1 x 10
-3
)
Final visual inspection
Method 2009
Test methods are referenced to MIL-STD-883 as determined by MIL-PRF-38534.
Notes:
1. refers to products that do not offer QMl screening.
2. Standard and /ES, non-QML products, do not meet all of the requirements of MIL-PRF-38534.
3. Burn-in designed to bring the case temperature to the maximum case temperature of the product. Refer to the specific product information
for the maximum case temperature.
standard
nOn-Qml
2
yes
no
no
/es
nOn-Qml
2
yes
yes
yes
no
yes
no
no
yes
yes
yes
yes
yes
yes
no
yes
FMD28-461 EMI Input Filters, FMD28 Rev C - 20100226. This revision supersedes all previous releases. All technical information is believed to be accu-
rate, but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make changes in products or specifications without notice.
FMD Series EMI Filters are a trademark of Interpoint. Copyright © 1999 - 2010 Interpoint Corporation. All rights reserved. www.interpoint.com
Page 8 of 8