3 Volt Intel® Advanced+ Boot Block Flash Memory Stacked-CSP Family
5.0
Electrical Specifications
5.1
Absolute Maximum Ratings
Warning: Stressing the device beyond the “Absolute Maximum Ratings” may cause permanent damage.
These are stress ratings only. Operation beyond the “Operating Conditions” is not recommended
and extended exposure beyond the “Operating Conditions” may affect device reliability.
NOTICE: This datasheet contains information on products in full production. The specifications are subject to
change without notice. Verify with your local Intel Sales office that you have the latest datasheet before finalizing a
design.
Table 9. Absolute Maximum Ratings
Parameter
Extended Operating Temperature
Maximum Rating
Notes
During Read
–25°C to +85°C
During Flash Block Erase and Program
Temperature under Bias
Storage Temperature
–65°C to +125°C
–0.5 V to +3.3 V
Voltage on Any Ball (except F-VCC /F-VCCQ / S-VCC and F-VPP) with
Respect to GND
1
F-V Voltage (for Block Erase and Program) with Respect to GND
–0.5 V to +13.5 V
–0.2V to +3.3 V
100 mA
1,2,4
3
PP
F-V / F-V
/ S-V Supply Voltage with Respect to GND
CC
CC
CCQ
Output Short Circuit Current
NOTES:
1. Minimum DC voltage is –0.5 V on input/output balls. During transitions, this level may undershoot to –
2.0 V for periods < 20 ns. Maximum DC voltage on input/output balls is F-V / F-V
/ S-V + 0.5 V
CC
CCQ
CC
which, during transitions, may overshoot to
F-V / F-V
/ S-V + 2.0 V for periods < 20 ns.
CC
CCQ
CC
2. Maximum DC voltage on F-V may overshoot to +14.0 V for periods < 20 ns.
PP
3. F-V voltage is normally 1.65 V–3.3 V. Connection to supply of 11.4 V–12.6 V can only be done for
PP
1000 cycles on the main blocks and 2500 cycles on the parameter blocks during program/erase. F-V
may be connected to 12 V for a total of 80 hours maximum. See Section 4.2.1 for details
4. Output shorted for no more than one second. No more than one output shorted at a time.
PP
24
Datasheet
INTEL [ INTEL ]
