欢迎访问ic37.com |
会员登录 免费注册
发布采购

571 参数 Datasheet PDF下载

571图片预览
型号: 571
PDF下载: 下载PDF文件 查看货源
内容描述: 奔腾4处理器,支持超线程技术 [Pentium 4 Processors Supporting Hyper-Threading Technology]
分类和应用:
文件页数/大小: 96 页 / 1585 K
品牌: INTEL [ INTEL ]
 浏览型号571的Datasheet PDF文件第88页浏览型号571的Datasheet PDF文件第89页浏览型号571的Datasheet PDF文件第90页浏览型号571的Datasheet PDF文件第91页浏览型号571的Datasheet PDF文件第92页浏览型号571的Datasheet PDF文件第93页浏览型号571的Datasheet PDF文件第94页浏览型号571的Datasheet PDF文件第95页  
Boxed Processor Specifications  
Table 7-2. Fan Heatsink Power and Signal Specifications  
Boxed Processor Fan  
Heatsink Set Point (ºC)  
Boxed Processor Fan Speed  
Notes  
When the internal chassis temperature is below or equal to this set point,  
the fan operates at its lowest speed. Recommended maximum internal  
chassis temperature for nominal operating environment.  
1
X 30  
When the internal chassis temperature is at this point, the fan operates  
between its lowest and highest speeds. Recommended maximum  
internal chassis temperature for worst-case operating environment.  
Y = 34  
-
-
When the internal chassis temperature is above or equal to this set point,  
the fan operates at its highest speed.  
Z 38  
NOTES:  
1.  
Set point variance is approximately ± 1 °C from fan heatsink to fan heatsink.  
If the boxed processor fan heatsink 4-pin connector is connected to a 4-pin motherboard header and  
the motherboard is designed with a fan speed controller with PWM output (CONTROL see  
Table 7-1) and remote thermal diode measurement capability the boxed processor will operate as  
follows:  
As processor power has increased the required thermal solutions have generated increasingly more  
noise. Intel has added an option to the boxed processor that allows system integrators to have a  
quieter system in the most common usage.  
The 4th wire PWM solution provides better control over chassis acoustics. This is achieved by  
more accurate measurement of processor die temperature through the processor's temperature  
diode (T  
). Fan RPM is modulated through the use of an ASIC located on the motherboard that  
diode  
sends out a PWM control signal to the 4th pin of the connector labeled as CONTROL. The fan  
speed is based on actual processor temperature instead of internal ambient chassis temperatures.  
If the new 4-pin active fan heat sink solution is connected to an older 3-pin baseboard processor fan  
header, it will default back to a thermistor controlled mode, allowing compatibility with existing 3-  
pin baseboard designs. Under thermistor controlled mode, the fan RPM is automatically varied  
based on the Tinlet temperature measured by a thermistor located at the fan inlet.  
For more details on specific motherboard requirements for 4-wire based fan speed control see the  
®
®
Intel Pentium 4 Processor on 90 nm Process in the 775-Land Package Thermal Design Guide.  
§
96  
Datasheet