A10-DATASHEET
2015.12.31
10
DC Characteristics
Symbol
Description
Condition
Minimum (17)
1.71
Typical
1.8
Maximum (17)
1.89
Unit
VCCIOREF_HPS
VCCPLL_HPS
HPS I/O pre-driver power supply
—
—
V
V
HPS PLL analog voltage regulator
power supply
1.71
1.8
1.89
Related Information
Recommended Operating Conditions on page 4
Provides the steady-state voltage values for the FPGA portion of the device.
DC Characteristics
The OCT variation after power-up calibration specifications will be available in a future release of the Arria 10 Device Datasheet.
Supply Current and Power Consumption
Altera offers two ways to estimate power for your design—the Excel-based Early Power Estimator (EPE) and the Quartus Prime PowerPlay Power
Analyzer feature.
Use the Excel-based EPE before you start your design to estimate the supply current for your design. The EPE provides a magnitude estimate of the
device power because these currents vary greatly with the usage of the resources.
The Quartus Prime PowerPlay Power Analyzer provides better quality estimates based on the specifics of the design after you complete place-and-
route. The PowerPlay Power Analyzer can apply a combination of user-entered, simulation-derived, and estimated signal activities that, when
combined with detailed circuit models, yield very accurate power estimates.
Related Information
•
PowerPlay Early Power Estimator User Guide
Provides more information about power estimation tools.
PowerPlay Power Analysis chapter, Quartus Prime Handbook
Provides more information about power estimation tools.
•
(17)
This value describes the budget for the DC (static) power supply tolerance and does not include the dynamic tolerance requirements. Refer to the
PDN tool for the additional budget for the dynamic tolerance requirements.
Arria 10 Device Datasheet
Send Feedback
Altera Corporation