IL34063A
ORDERING INFORMATION
Pin connection
Device
Temperature Range Package
34063AD
34063AN
SO-8
Plastic DIP
0° to +70°C
ELECTRICAL CHARACTERICISTICS
(VCC = 5.0 V, TA= 0 to +70oC unless otherwise specified.)
Characteristics
Symbol
Min
Typ
Max
Unit
OSCILLATOR
Frequency (VPin 5 = 0 V, CT = 1.0 nF, TA = 25°C)
Charge Current (VCC = 5.0 V to 40 V, TA = 25°C)
fosc
Ichg
24
24
33
33
42
42
kHz
mA
mA
—
Discharge Current (VCC = 5.0 V to 40 V, TA = 25°C)
Discharge to Charge Current Ratio (Pin7 to Vcc, TA=25°C)
Current Limit Sense Voltage (Ichg = Idischg, TA = 25°C)
Idischg
140
200
6.2
300
260
7.5
350
Idischg/Ichg 5.2
Vipk(sense) 250
mV
OUTPUT SWITCH (Note 3)
Saturation Voltage, Darlington Connection (ISW = 1.0 A, Pins 1,
8 connected)
VCE(sat)
—
—
1.0
1.3
0.7
V
V
VCE(sat)
0.45
Saturation Voltage (ISW = 1.0 A, RPin 8 = 82 W to VCC.
Forced b = 20)
DC Current Gain (ISW = 1.0 A, VCE = 5.0 V, TA = 25°C)
Collector Off-State Current (VCE = 40V)
hFE
IC(off)
50
—
120
0.01
—
100
—
mA
COMPARATOR
Threshold Voltage (TA = 25°C)
(TA = TLOW to THIGH
Threshold Voltage (TA = 25°C) **
Vth
1.225
1.21
1.2375
1.25
—
1.25
1.275
1.29
1.2625
V
)
Vth
V
Threshold Voltage Line Regulation (VCC = 3 0 V to 40 V)
Input Bias Current (Vin=0V)
Regline
IIB
1.4
-40
5.0
-400
mV
nA
—
TOTAL DEVICE
Supply Current (VCC = 5 0 V to 40 V, CT = 1 0 nF, Vpin7 = VCC
VPin5 > Vth, Pin 2 = Gnd, Remaining pins open)
.
ICC
2.5
4.0
mA
NOTES:
1. Maximum package power dissipation limits must be observed.
2. Low duty cycle pulse techniques are used during test to maintain Junction temperature as close to ambient temperature as
possible
3. If the output switch is driven into hard saturation (non Darlington configuration) at low switch currents (< 300 mA) and high
driver currents (>30 mA), it may take up to 2.0 ms to come out of saturation This condition will shorten the off' time at frequencies
> 30 kHz, and is magnified at high temperatures This condition does not occur with a Darlington configuration, since the output
switch cannot saturate If a non Darlington configuration is used, the following output drive condition is recommended
Forced b of output switch = IC, output/(Ic, driver -7.0 mA*) > 10
*The 100 W. resistor in the emitter of the driver device requires about 7.0 mA before the output switch conducts
**Possible version for shipment
Rev. 01