ICS307-03
SERIALLY PROGRAMMABLE CLOCK SOURCE
SER PROG CLOCK SYNTHESIZER
Programming Interface
The dynamic register within the ICS307-03 controls the entire device and may be reprogrammed any time after
power is properly applied. If V or R values are changed, the frequency will transition smoothly to the new value
without glitches or short cycles. However, changing any divider or mux in the output signal path may generate a
glitch.
The register is 132 bits in length and accepts the MSB first. The SCLK signal latches the current data bit value in
the rising edge. It latches the most recently shifted 132 bit values into the control register of device whenever CS is
high. Care must be taken to ensure that CS is always low until the system is ready to load in a new register value
and that SCLK is never toggled high when CS is high.
The register can be programmed any time after power is applied, even while in power-down (pin 15 or bit 112 held
low) with the waveform and timing shown below:.
Figure 2: ICS307-03 Programming Timing Diagram
DIN
131
130
129
thold
128
1
0
2
tsetup
SCLK
CS
tw
ts
Table 8: AC Parameters for Programming the ICS307-03
Parameter
Condition
Setup time
Min.
2.5
2.5
2.5
10
Max.
Units
ns
t
SETUP
t
Hold time after SCLK
Data wait time
ns
HOLD
t
ns
W
t
Strobe pulse width
SCLK Frequency
ns
S
200
MHz
Programming with VersaClock Software
The VersaClock II Software not only generates the programming word for the user, it can also be used to program the device
via the host computer’s parallel port. Demonstration boards are available from IDT that allows the VersaClock II S/W to
directly connect the ICS307-03 to a Windows based PC’s DB-25 parallel port connector and programmed simply by pressing
the “Program Part” button.
IDT® SERIALLY PROGRAMMABLE CLOCK SOURCE
10
ICS307-03
REV L 032911
IDT [ INTEGRATED DEVICE TECHNOLOGY ]
