ICS1893CF Data Sheet Rev. F - Release
Chapter 8 Pin Diagram, Listings, and Descriptions
Table 8-11. ICS1893CK Configuration Pins
Signal Name
REF_IN
Pin No.
47
Signals Description
Frequency Ref Input: 25MHz Clock or Crystal
Frequency Ref Output for Crystal
System Reset (active low)
REF_OUT
RESETn
46
17
8.3.2 Transformer Interface Pins
Transformer connections on the ICS1893CK signals TP_AP, TP_AN, TP_BP and TP_BN are shown in
Table 8-12. The previous TP_CT pin used on the ICS1893CF is not used with the ICS1893CK. The typical
Twisted Pair Transformers connections are shown in Chapter 5. The transformer must be 1:1 ratio and
symetrical for 10/100 MDI/MDIX applications since the transmit twisted pair and receive twisted pair are
interchangeable. ICS1893 PHYs do not have power connections to the Transformer. All transformer power
is supplied by the ICS1893CK.
Note the twisted pairs are polarity sensitive and must connect to the RJ45 with the same polarity as shown
in the figure. Pay particular attention to polarity of the the “B” pair being reversed in pad sequence.
Table 8-12. ICS1893CK Transformer Interface Pins
Signal Name
TP_AP
Pin No.
Signals Description
Twisted Pair A Positive
Twisted Pair A Negative
Twisted Pair B Positive
Twisted Pair B Negative
4
5
9
8
TP_AN
TP_BP
TP_BN
ICS1893CF, Rev. F, 03/01/07
Mar. 2007
Copyright © 2007, Integrated Device Technology, Inc.
All rights reserved.
97
ICSI [ INTEGRATED CIRCUIT SOLUTION INC ]
