MB3U, MB3U-I2C
BiSS TO PC-USB ADAPTER
Rev B2, Page 6/7
Button
Initialize
Read Output
Write File
Description
Initializes
BiSS
bus after configurations are made
Reads in sensor data
Saves sensor data to file
Figure 6:
Middle section
(one tab each per slave)
Button
Read Reg
Write Reg
Load File
Save File
Description
Loads register configuration from sensors to software GUI (hex)
Transfers the displayed register configuration to sensors (hex)
Loads register configuration from a file (hex)
Saves register configuration to a file (hex)
Figure 7:
Lower section
(valid for all slaves)
Button
Read Reg
Write Reg
Load File
Save File
SENSSEL
Reset SENSSEL
Code
Send BiSS Command
Description
see Middle Section
see Middle Section
see Middle Section
see Middle Section
Mask for slave selection. For broadcast please select none
Clears all SENSSEL checkboxes
BiSS
command selection
Sends the chosen command to the selected slaves
ICHAUS [ IC-HAUS GMBH ]
