Datasheet
PowerPC 970FX RISC Microprocessor
Table 5-1. PowerPC 970FX RISC Microprocessor Bus Configuration (Page 2 of 2)
BUS_CFG(0:2)
Ratio
12:1
Notes
101
110
111
3
1
16:1
Not valid
Note: BUS_CFG bits can be changed by SCOM commands during the POR sequence. See the PowerPC 970FX Power On Reset
Application Note.
Notes:
1. Bus ratios of 8:1 and 16:1 are not supported for processor interface (PI) input functionality or for power tuning.
2. Limited power-tuning frequency scaling.
3. No power-tuning frequency scaling.
The bus frequency multiplier ratio typically indicates the required PLL multiplier setting. Ratios based on
multiples of 3 (3:1, 6:1, 12:1) should always use PLLMULT = ‘0’ (low) for a PLL multiplier of 12. The required
core frequency should be divided by 12 to determine the required input SYSCLK frequency. Ratios based on
multiples of 2 (2:1, 4:1, 8:1, 16:1) should always use PLLMULT = ‘1’ (high) to multiply SYSCLK by 8.
Note: Using bus frequency ratios of 3:1, 6:1 or 12:1 with PLLMULT = 1 or ratios of 8:1 or 16:1 with
PLLMULT = 0 is not recommended. Internal clock synchronization delays might reduce performance.
After the correct BUS_CFG(0:2) and PLLMULT pin settings are determined, the required SYSCLK input
frequency can be determined. The selected SYSCLK input frequency should be within the minimum and
maximum frequencies specified in Table 3-8 Clock ac Timing Specifications on page 26.
5.2.2 PLL_RANGE Configuration
Table 5-2 shows the PLL voltage controlled oscillator (VCO) configuration for the PowerPC 970FX, using the
pins PLL_RANGE1 and PLL_RANGE0.
Table 5-2. PowerPC 970FX RISC Microprocessor PLL Configuration
PLL_RANGE(1:0) Settings
Range Name
Low
PLL_RANGE1
PLL_RANGE0
Frequency Range
Frequency < 1.2 GHz
1.2 GHz < Frequency < 1.8 GHz
1.8 GHz < Frequency
Reserved
0
0
1
1
0
1
0
1
Medium
High
Reserved
Notes:
1. The PLL_MULT and PLL_RANGE(1:0) bits can be overwritten by JTAG commands, and the BUS_CFG bits can be changed by
SCOM commands, during the POR sequence. See the 970FX PowerPC 970FX Power On Reset Application Note for more details.
2. PLL frequency range settings are not an indicator of available PowerPC 970FX processor speeds.
5.2.3 Typical PLL and SYSCLK Configurations
Table 5-3 provides a few examples of typical system configurations.
System Design Information
Page 64 of 78
Version 2.5
March 26, 2007