IBM11M8735C
IBM11M8735CB
8M x 72 DRAM MODULE
DC Electrical Characteristics (T = 0 to +70˚C, V = 3.3V ± 0.3V or V = 5.0V ± 0.5V)
A
CC
CC
Symbol
Parameter
Min. Max.
Units
mA
Notes
1, 2, 3
Operating Current
-60
—
—
1386
1206
ICC1
Average Power Supply Operating Current
(RAS, CAS, Address Cycling: tRC = tRC min.)
-70
Standby Current (TTL)
Power Supply Standby Current
(RAS = CAS = VIH)
ICC2
ICC3
ICC4
ICC5
ICC6
—
72
mA
mA
mA
mA
mA
RAS Only Refresh Current
Average Power Supply Current, RAS Only Mode
(RAS Cycling, CAS = VIH: tRC = tRC min)
-60
-70
-60
-70
—
—
—
—
1386
1206
1206
1026
1, 3, 4
1, 2, 3
EDO Page Mode Current
Average Power Supply Current, EDO Page Mode
(RAS = VIL, CAS, Address Cycling: tHPC = tHPC min)
Standby Current (CMOS)
Power Supply Standby Current
(RAS = CAS = VCC - 0.2V)
—
36
CAS Before RAS Refresh Current
Average Power Supply Current, CAS Before RAS Mode
(RAS, CAS, Cycling: tRC = tRC min)
-60
-70
—
—
1386
1206
1, 3, 4
CAS, WE,
OE, A0, B0
-10
+10
Input Leakage Current
Input Leakage Current, any input
(0.0 ≤ VIN ≤ (VCC + 0.3V)), All Other Pins Not Under Test = 0V
II(L)
µA
A1 - A11, DQ -20
+20
+90
RAS
-90
-10
Output Leakage Current
(DOUT is disabled, 0.0 ≤ VOUT ≤ VCC
IO(L)
+10
VCC
µA
)
Output Level (TTL)
Output “H” Level Voltage
(IOUT = -2.5mA for 3.3V, or IOUT = -5mA for 5.0V)
VOH
2.4
0.0
V
Output Level (TTL)
Output “L” Level Voltage
VOL
0.4
V
(IOUT = +2.1mA for 3.3V, or IOUT = +4.2mA for 5.0V)
1. ICC1, ICC3, ICC4 and ICC6 depend on cycle rate.
2. ICC1 and ICC4 depend on output loading. Specified values are obtained with the output open.
3. Address can be changed once or less while RAS =VIL. In the case of ICC4, it can be changed once or less when CAS =VIH.
4. Refresh current is specified for 1 bank active and 1 bank standby.
©IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
50H8010
SA14-4635-02
Revised 5/96
Page 6 of 29
IBM [ IBM ]
