Chapter 4. Evaluation Board
3. Setting of output condition of D0~D7 in STOP
Shorting the DSC0~DSC7 with the side of H can set the output condition of
¡ È ¡ È
corresponding D-output in STOP at
L
forcibly.
To set the condition of usual output (the condition before STOP started is
maintained), short them with the side of L.
Setting pin
D0
D1
D2
D3
D4
D5
D6
D7
Short post
DSC0
DSC1
DSC2
DSC3
DSC4
DSC5
DSC6
DSC7
Forced setting at
¡ È ¡ È
L
in STOP
release
H
L
H
L
H
L
H
L
H
L
H
L
H
L
H
L
Usual output in
STOP released
4. Setting of watch dog timer release with REMOUT output
The watch dog timer can be reset with REMOUT output signals by shorting
the WDTM with the side of L.
If the WDT resetting with REMOUT output signals is not desired, short it
with the side of H.
Short post
Reset timer
WDTM
L
Do not reset timer
H
[S2] External STOP setting
STOP can be set from the outside by shorting the S2 toward the side of H.
Usually, short it toward the side of L.
[S3] Power supply connection
This selection should be strapped to VDD
.
4 - 4
HYNIX [ HYNIX SEMICONDUCTOR ]
