Chapter 5. Software
BP (Break Point set), BL (Break point List)
[Function]
BP
To set the break point.
BL
BPS
To display the set break point
To set step break point.
[Format]
BP[n]_adr[_m]
n :
Set break No. 0~9.
adr :
m :
Set address for setting break
Valid only when n=0, setting No. of times to pass the break
point. The m range is 1 m 255. m value should be set in
hexadecimal.
BPS_st
st :
Set No. of steps.
st range is 1 st 2147483647.
st value should be set in decimal.
BPI
BPO
BL
[Explanation]
This command is used to the break point.
Break on this simulator is to stop after executing the command on the specified
address.
When `BPS st` is specified, the system stops when the value on the machine
cycle register becomes equal to st.
When `BPI` is specified, the system stops before command execution every time
command input is made.
Unassemble displayed in this case is the address with input command.
When `BPO` is specified, the system displays the value on that occasion on CRT
and stops every time output command is made.
When `BP` only or `BL` is specified, the state of the currently set break point is
displayed.
It is possible to used symbols for specifying adr.
When `n` is omitted in break setting command, No. shall be allocated from 1 to all
empty No.
5 - 20