B
Technical DocumentⅡ
Ⅱ
Connector Mounting Method
1. Soldering Method
This connector and board mounting method uses soldering at the four dip locations marked A at the left and
right sides as well as the two surface mounting locations marked B at the left and right sides for a total of six
locations.
Location A represents board through holes of 1.8mm diameter and 1mm diameter, whereas
location B represents pads of 2.8
×
1.85mm width. (See the board mounting diagram.)
Dec.1.2018
Nov.1.2016 Copyright 2016 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
2018
As illustrated in the diagram below, the opening portion of the connector is either inserted into the body of
the set or inserted into a rectangular hole of the set.
Connector opening portion
Board
Connector
2. Soldering and Screw Fastening Method
When there is not sufficient strength with the connector opening portion at the set, the mounting holes C (as
in Figure 1) at the left and right sides of the connector are used after the solder mounting to further fix the
connector with M2 screws.
The connector can be fixed to just the board with this method (as in Figure 2); however, in consideration of
connector twisting, the most effective mounting method is to fix the connector to both the body and the
board with screws as illustrated in Figures 3 and 4.
（Figure 1）
Board
Body of the set
Nut anchoring
Tapping screw anchoring
（Figure 2）
（Figure 3）
（Figure 4）
262
Powered by TCPDF (www.tcpdf.org)
04/2009
HRS [ HIROSE ELECTRIC ]
