Inputs and Outputs (continued)
Rear panel (continued)
Monitor output
Connector
Format
Resolution
VGA compatible, 15-pin mini D-SUB
VGA (31.5 kHz horizontal, 60 Hz vertical sync rates, non-interlaced) Analog RGB
640 X 480
Noise source drive output (used by Option 219)
Connector
Output voltage
BNC female
On 28.0 ± 0.1 V (60 mA maximum)
Off < 1 V
Remote programming
GPIB interface
Connector
IEEE-488 bus connector
GPIB codes SH1, AH1, T6, SR1, RL1, PP0, DC1, C1, C2, C3, and C28, DT1, L4, C0
9-pin D-SUB male (factory use only)
Serial interface connector
LAN TCP/IP interface
RJ45 Ethertwist
USB interface (Option 111, standard) Slave mode/device-side only, USB 2.0 compliant, type B connector
Parallel printer interface connector
25-pin D-SUB female
321.4 MHz IF output1
Connector
Frequency
Conversion gain
SMA female, 50 Ω nominal
321.4 MHz nominal
• Low band (3 Hz to 3.05 GHz)
• High/mm band (2.85 GHz to
PSA’s upper frequency limit)
• High/mm band (2.85 GHz to
PSA’s upper frequency limit);
preselector off (Opt 123)
+2 to +4 dB nominal
–6 to –8 dB nominal
–9 to –17 dB nominal
Bandwidth (-3 dBm)
• Low band (3 Hz to 3.05 GHz)
• High band (2.85 to 26.5 GHz)
• mm band (26.5 to 50 GHz)
• High/mm band (2.85 GHz to
PSA’s upper frequency limit);
preselector off (Option 123)
Pre-sel tune output
40 MHz or 60 MHz2 nominal
35 to 70 MHz3 nominal
40 MHz or 60 MHz2 nominal
240 MHz nominal
Connector
BNC female
1. Not available for the E4447A.
2. 40 MHz standard, 60 MHz with Option 122 or 140 installed in instrument. When Option 122 or 140 is installed, the IF output signal
is now centered at 300 MHz and the BW of the output centered at 300 MHz is approximately 95 MHz.
3. The bandwidth in the microwave preselected bands increases approximately monotonically between the lowest and highest tuned
frequencies. Refer to the PSA Specifications Guide (E4440-90606) for more details.
20
HP [ HEWLETT-PACKARD ]
